Product Specs

ManualsBrandsNight Owl ManualsElectronicsWIFI MODULE

2.4G WIFI Module

Product Specification

IEEE 802.11 b/g/n 2.4GHz 2T2R WiFi Module

Project Name

Model NO

Customer

Customer’s Part NO

Sales:

Feedback of customer’s Confirmation

We accept the specification after Confirmed.

Customer Customer signature Approved Date

RTL8192EU

FCC ID: 2ASLP-RTL8192EU

Summary of content (9 pages)

PAGE 1
FCC ID: 2ASLP-RTL8192EU Product Specification IEEE 802.11 b/g/n 2.4GHz 2T2R WiFi Module Project Name 2.4G WIFI Module Model NO RTL8192EU Customer Customer’s Part NO Sales: Feedback of customer’s Confirmation We accept the specification after Confirmed.
PAGE 2
CONTENTS 0 REVESION HISTORY......................................................................................................................... 3 0.1 MODEL NO DEFINITION .............................................................................................................. 3 1 2 3 4 INTRODUCTIONS .............................................................................................................................. 4 1.1 OVERVIEW......................................................
PAGE 3
0. Revision History REV NO Date Modifications Draft 0.1.
PAGE 4
1. Introduction 1.1 Overview T8192E md is a highly integrated and excellent performance Wireless LAN (WLAN) USB2.0 network interface device. High-speed wireless connection up to 150 Mbps. The general hardware for the module is shown in Figure 1. This WLAN Module design is based on Realtek RTL8192EU. It is a highly integrated single-chip MIMO ( Multiple In Multiple Out ) Wireless LAN (WLAN) USB2.0 network interface controller complying with the 802.11n specification.
PAGE 5
2. GENERAL SPECIFICATION 2.1 WiFi RF Specifications Features Descriptions Main Chipset RTL8192EU Frequency Range 2.402～2.494GHz Operating Voltage 3.3Vdc ±5% I/O supply voltage Host Interface WiFi: USB Standards WiFi: IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, Modulation WiFi: 802.11b: CCK(11, 5.5Mbps), QPSK(2Mbps), BPSK(1Mbps), 802.11 g/n: OFDM PHY Data rates WiFi: 802.11b: 11,5.5,2,1 Mbps 802.11g: 54,48,36,24,18,12,9,6 Mbps 802.11n: up to 150Mbps Transmit Output WiFi: 802.
PAGE 6
Security Antenna OS Supported Dimension WiFi: WPA, WPA-PSK, WPA2, WPA2-PSK, WEP 64bit & 128bit, IPEX Android /Linux/ Win CE /iOS /XP/WIN7 Typical L38.0mm*W18.1mm*T5.6mm 2.2 Power Consumption Power Consumption (Typical by using SWR) WiFi only: LINK: 400mA TX Mode: (Continuous mode) 360mA (MCS7/BW20M/16dBm) TX Mode: (Continuous mode) 500mA (CCK-1M/BW20M/18dBm) RX Mode: (Continuous mode) 350mA (MCS7 /-69dBm) 3. Mechanical Specification 3.1 Outline Drawing 3.
PAGE 7
4. Environmental Requirements 4.1 Operating& Storage Conditions Temperature: -20°C to +50°C Operating Relative Humidity: 10-90% (non-condensing) Temperature: -40°C to +80°C (non-operating) Storage Relative Humidity: 5-90% (non-condensing) MTBF (Mean Time Between Failures) Over 150,000hours 4.2 Recommended Reflow Profile Referred to IPC/JEDEC standard. Peak Temperature : <250°C Number of Times : ≤2 times 4.3 Patch WIFI modules installed before the notice: WIFI module installed note: 1.
PAGE 8
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 9
Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove tis RF module in the user’s manual of the end product which integrates this module. This module is intended for OEM integrator. The OEM integrator is still responsible for the FCC compliance requirement of the end product, which integrates this module.