Nietzsche Enterprise CO,LTD.
Content 00 Introduction 01-02 Specification 01 Applications 02 Network Overview 02 Hardware Overview 03 WZB-01USBC ZigBee-Dongle Getting start Install USB dongle driver Setting USB dongle configuration 03 04-07 04 04-05 Computer COM Port setting 06 Make Network Link & LED indication 07 Accessories CD Quickview Data Software User Manual Safety notice A. Please read and follow the instructions before use of this product. B.
Introduction 01 WZB-01USBC Wireless ZigBee Dongle, for ModBus, General Applications WZB-01USBDC Wireless ZigBee Dongle, for DIO Applications Introduction WZB-01USB series ZigBee USB Dongle features as a coordinator; easy to link and connect to the Host computer, provides fully compliant wireless ZigBee communications with routers/end device, suitable for home/building automation,Industrial control and monitoring, lower power wireless sensor networks & consumer Electronic Applications.
Introduction 02 Applications ● Industrial and Domestic Applications ● Service-based monitoring, security and awareness systems ● Home Area Networks (HAN) ● Home/ Building automation Network Overview R ZigBee Network Topology Models Network topology Star Mesh ZigBee coordinator(ZC) Full Funcation Device(FFD,Router) Reduced Function Device(RFD) Network application Controller PC DIO WZB-D03 MD End device USB WZB-01USB dongle for Modbus/DIO protrol NB PLC RS485 RS485 WZB-02485 End device Router Coord
Hardware Overview 03 WZB-01USBC ZigBee-Dongle Link button Reset / Add / Remove Antenna Wireless data transmission to PC S1 USB socket LED Light For indication link status
Getting start 04 Install USB dongle driver To install the PL-2303 USB Driver From the CD enclosed
Getting start 06 COM Port setting The WZB-01USBC ZigBee dongle must be plugged into the PC. Go to My Computer, click right button on the mouse, select Content, choose Hardware, click Device Manager, then set COM port. (Prolific USB-to-Serial Comm Port) as below.
Getting start 07 Make Network Link & LED indication Function Join to network Remove the joined device Reset or Refresh network Operation Dongle Dongle Dongle Press “S1” once Press “S1” twice Press “S1” 3 seconds LED Indicator Blue LED blinking flash, 30 seconds allowed for join turn to intermittent flash means well linked Blue LED blinking flashes, 30 seconds allowed to remove turn to intermittent flashlight means removed. Blue and red LED On for 1 second turn to intermittent flash.
Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. (15.21) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.(15.