The Federal Communication Commission Statement This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication.
1. Overview The ultra wide range M02 ZigBee module, equipped with Texas Instrument CC2530 chipset, is stamp-type PCB which allows an easy integration into your embedded systems – with selectable OTA (over-the-air) firmware upgrade option. The module has an I-PEX connector reserved for applications which need a broader coverage and better antenna pattern. And it is also particularly applicable for devices using 20 GPIO for UART, SPI, I2C, AI, DI and DO for building IEEE 802.15.
3. Features and Specifications Transmitting Protocol ZigBee: HA profile or Standard Modbus RTU Addressing Depends on customer (default: MAC address) Wireless Protocol IEEE 802.15.4 ZigBee2007/PRO Transmission Range Chip antenna: Up to 100 meters / 328 feet I-PEX antenna: Depends on designated antenna’s performance Operating Frequency 2.
4. Electrical and Physical Characteristics 4.1 Electrical and RF Characteristics Rating Value Units All Input/Output Pins -0.3 to +3.6 V Non-Operating Ambient Temperature Range -40 to +85 °C Characteristics Sym Notes Minimum Typical Maximum Units ADC Input Range 0 3.3 V ADC Input Resolution 7 12 bits ADC Input Impedance 55 MΩ PWM Output Resolution 12 bits 1.2 115.2 Kb/s Logic Low Input Level -0.3 0.5 V Logic High Input Level 2.5 3.
Number of RF Channels 16 RF Date Transmission Rate Symbol Rate Tolerance -1000 RF Channel Spacing 250 Kbps +1000 ppm 5 MHz Receiver Sensitivity, @1% PER -95 dBm Interference Rejection, ±5MHz 35.5 dB Interference Rejection, ±10MHz 45.5 dB Interference Rejection, ±20MHz 48.8 dB Maximum RF Transmit Power 19 Optimum Antenna Impedance Ω 50 4.2 Mechanical Drawing 2.25mm 34mm 26mm 1.25mm 15.7mm 17.5mm 19mm 2mm 0.
4.3 Pin I/O Assignment and Description 4.3.
4.3.2 Pin Description (for Reference) PIN NO. PIN NAME PIN TYPE DESCRIPTION 1 GND GND Power supply and signal ground 2 P2_2 Digital I/O Debug CLK 3 P2_1 Digital I/O Debug DAT 4 P2_0 Digital I/O Reserved (Programmable) 5 P1_7 Digital I/O Serial data input RXD UART 6 P1_6 Digital I/O Serial data output TXD UART 7 P1_5 Digital I/O LED2 indicator, active-low (ref.
5. Regulatory Information 5.1 FCC ID and FCC Statement FCC ID: Q2N-M02 FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and; (2) This device must accept any interference received, including interference that may cause undesired operation. 6.