NT 150 Technical and Maintenance Manual Commissar Inc REMOTE CONTROL FEATURE The NT 150 is equipped with a 8 pin RS 232 connector that allows all the mains telemetry functions. The software is supplied with the unit and with this CD rom it's possible to monitor and to change the main parameters other NT 150 on the computer's screen, The NT 1501st also supplied with the interlock connector that allows to switch the power on and off simply by grounding the inner conductor of the BNC.
NT 180 Technical and Maintenance Manual Nicolas inc RUNNING THE PROGRAM Once the program is running, from the main screen iris necessary to click the POWER ON button; the screen will light up and a message" COMMUNICATION IN PROGRESS "will appear. After few seconds, on the left side of the screen, the operating frequency will appear together with all the other parameters. If not, check the Communication port setting (COM-COM 2). To change it, click the File menu and then select "set Port".
NT 150 Technical and Maintenance Manual Nicodemus Inc NT 150 PROGRAMMING Connect a 50 ohm load or 50 ohm antenna to the RF output, connect the equipment info a mains supply (100+240 VAC). The equipment is factory per-settc 10 W. Switch ON the power and the yellow V POWER LED will light. The Display will show: WAIT LU PROGRAM ) SETTING After 3 seconds the green PLL LOCK led will light and the Display will show an increasing bar.
NT 150 Technical and Maintenance Manual Nicodemus Inc Display Password The Password mode is factory set to enable, and is not possible change this setting. The default password is 123. The way for changing the password is the following: «Press the PROGRAM key for 3 seconds; PASSWORD |) PROGRAM 0123456789 (7) sere » Press the Program key to move the underscore character position at the required digit, and press the SETTING key fo confirm the digit.
NT 150 Technical and Maintenance Anus! Nicolas Inc If the password is not correct an error is displayed ERROR L] PROGRAM PASSWORD (1) serve After a few seconds the display will show the parameters again. When the password is correct, the display will show NEW PASS. = SET. | PROGRAM NEW FREQ. = PRG [7] server Ta change the password press the SETTING key. To change the frequency press the PROGRAM key. CHANGE OF PASSWORD The password is set at the factory and corresponds to the numbers 1-2-3.
NT 150 Technical and Maintenance Anus! Insomnia inc » For changing the password proceed with the same method for the required password: NEW PASSWORD 0123456789 UJ O The confirmation password will be required. CONFIRMATION 0123456789 J UJ if the password is correct the display will show: STORED NEW PASSWORD LJ 0 ERROR CONFIRMATION UJ Od IMPORTANT NOTE PROGRAM SETTING PROGRAM SETTING PROGRAM SETTING lithe confirmation password is wrong the display will show.
NT 150 Technical and Maintenance Manual Display Change of Frequency. Nicodemus Inc » Press the PROGRAM key for 3 seconds and enter the correct password. At this point press again the SELECT key: NEW PASS . = SET. NEW FREQ. = PRG {] PROGRAM [1] serve * Press the PROGRAM key to change the desired digit and press the SETTING key to confirm it. FREQUENCY ? MHz 103.900 J PROGRAM (1) serrate The underscore character indicates which digit can be change. To move the underscore character hit the PROGRAM key.