REV. A ECO No. First release APPROVED NAME Product Manager R&D Manager Testing Manufacturing Eng. QA Engineering SIGNATURE NAME DATE SIGNATURE DESCRIPTION: INSTALLATION GUIDE NTR Shay Versano Shay Versano SH 1 OF DRAW No. DC00019-001 REV.
Table of Contents FCC Warning ................................................................................................................... 3 Mechanical Assembly..................................................................................................... 4 Front Box ....................................................................................................................... 4 Gland .......................................................................................................
FCC Warning FCC Warning Modifications not expressly approved by the manufacturer could void the user authority to operate the equipment under FCC Rules. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Mechanical Assembly Front Box Attach standoffs with plain washer, nut and spring washer to the lower board. Attach the lower board into the front box and assemble screws. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Gland Assemble gland with nut and washer. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
PCB Assembly Assemble the PCB into the front box and hold it with standoffs, screws, and washers. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
PCB Cover Place the RF shield above PCB and assemble screws and washers. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Label Place warning label on top of the RF shield. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Antenna Place the antenna and assemble plastic screws. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Mounting Place the bracket and tighten with screws. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
AC Cable place the AC cable into the front box Assemble AC cable with screws DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Top Cover Place the top cover on the front box and assemble screws. Sealed the top cover with strips. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Final Assembly DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Field Installation General Instructions The NTR must be installed at least 3 meters above the floor. Select the installation location in where no moving/mobile nor static objects would exist or enter into within 2 meters of the NTR surrounding, excluding the wall or pipe where the NTR is installed on. Installation Steps Locate installation place, on a roof of a dominate building in the area where the NTR services are required. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Mark 2 point for drilling. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
drill 2 holes. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
assemble screw-holders. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
Assemble 2 screws. DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.
NTR Final installation DRAW NO.: DC00019-001 DESCRIPTION: FINAL ASSEMBLY REPEATER RX-TX REV A SH.