INSTRUCTION MANUAL OF IW261C-N COLOR WEATHER FORECAST STATION V1.1 - June. 18, 2015 INSTRUCTION MANUAL OF IW261C-N COLOR WEATHER FORECAST STATION V1.1 - June. 18, 2015 Stand RF Transmission LED Stand FCC ID: TIUIW261C INPUT : DC5V BATTERY: DC4.5V 3xAAA 1. INSERT THE STAND HORIZONTALLY 2. THEN ROTATE THE STAND CLOCKWISE BY 90° TO SECURE IT / Reset Reset Outdoor wireless transmitter BATTERY + / - DIRECTION LED FCC ID: TIUTW003 Model No. TW003 RF 433.92MHz 1.
FEATURE LIST 4.7” / 120mm (diagonal) display with 1.
Installing backup batteries to your weather station Your weather station requires 3 “AAA” alkaline batteries to provide backup power to it in the event of a temporary power interruption. 1. 2. 3. 4. Place your unit face down on a flat surface. Slide and remove the battery cover at the bottom of your unit. Insert 3 “AAA” alkaline batteries into the battery compartment by observing the “+” and “-“ polarity as indicated. Replace the battery cover.
5. Then press once again, month digits flash. Press or button to set the month. 6. Then press once again, date digits flash. Press or button to set the date. 7. Then press once again, “m”, “d”, month-date digits flash. Press or to select month-date “m” “d” or date-month “d” “m” calendar display. 8. Then press once again, “SN” and “05”. Press or button to set the snooze duration from 5 minutes to 60 minutes. 9.
3. Your weather station will return to normal mode, or it will return to normal mode in around 10 seconds if no further press of any other buttons. TO TURN ON OR OFF YOUR DAILY ALARM Simply press to turn on or off the Alarm 1, Alarm 2, or Alarm 1 & 2. When Alarm 1 is turned on, the appears. When Alarm 2 is turned on, the appears. TO USE SNOOZE ALARM When time reaches your set alarm time, your weather station will give a beep sound to wake you up. The corresponding or will flash.
RAINY STORMY FROST ALERT Frost Alert Icon appears when outdoor temperature is below +3°C AIR PRESSURE TENDENCY INDICAOTRS When the arrow appears, the air pressure is increasing, the weather is expected to improve. When the arrow appears, the air pressure is decreasing, the weather is expected to become worse. When the arrow appears, the air pressure change is stable.
HOW TO SYNCHRONIZE YOUR WEATHER STATION WITH ANOTHER OUTDOOR TRANSMITTER 1. Press / CHANNEL at the back of your weather station, and humidity. icon appears under your outdoor temperature 2. Press and hold / CHANNEL until the icon blinks, your weather station is searching for the signal of another outdoor transmitter at Channel 2. 3.
Problem LCD is blank No Outdoor Temperature and Humidity is displayed Temperature, humidity, or air pressure is incorrect Solution 1. Press RESET on the main unit. 2. Replace fresh batteries in your weather station. 1. Press and hold ▲/ CHANNEL on the weather station. 2. Press and hold▲/ CHANNEL then press RESET on the outdoor transmitter. 3. Make sure the correct channel is selected on your weather station (default setting is – Channel 1) 4.
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Words in the figure: Figure 1: ENGLISH Outdoor humidity Outdoor sensor channel 1/2/3 Max / Min temperature & Humidity data Outdoor temperature Outdoor sensor low battery icon Barometric Pressure Weather forecast Storm warning icon Indoor humidity Frost alarm icon Indoor temperature Alarm 1 Alarm 2 Month/Day/Date Figure 2: SNOOZE / BACKLIGHT / CHANNEL SET / ALARM SET ALARM ON/OFF MEMORY (°C/°F) RESET BATTERY / BATTERY COVER HANGING HOLE STAND DESK STAND SLOT Figure 3: OUTDOOR TRANSMITTER LED INDICATO