User's Manual
Play the music with the Wireless Speaker
1. Long press the Music Button for 1.5 seconds and shows green light.
2. Check your mobile phone Bluetooth Device and then connect to NexTool Thunder.
3. It will shows Blue Light after successful connection. You could play music with
wireless speaker.
4. In the music mode，long press the button for 2 seconds and reset the
wireless speaker connection.
35lm~900lm
3lm~95lm
6lm~160lm
0.5lm~20lm
5lm~145lm
—
—
1lm~4.5lm
—
—
2.4h~40h
3h~32h
4h~48h
4h~45h
4h~45h
—
—
15h~30h
—
3h
245m
—
—
—
12m
—
—
—
—
—
Product
Description
Name
Name
Address
Address
Address/Website
Sale date
Model#
Phone
Phone
Invoice#
For after-sales service needs, please contact the customer service department
After-sales service phone: 86 - 662 - 369 2722
Business hours: Mon. to Sun. 8:00-17:15
Manufacturer: BINOVO MANUFACTURING CO., LTD.
Address: B9-3 Yinling Science and Technology Park, Jiangcheng, Yangjiang,
Guangdong, China
WARRANTY CARD
Retailer
Information
User
Information
This warranty policy is a legal document we manufacturer provide for our end user,
stipulating warranty services and other related matters. Please keep it properly. If
the retailer or other third party whom you buy the product from declares that it will
provide warranty service or other more services, the warranty service or other
services will be provided by the retailer or third party.
1. Instruction
This warranty service is only applicable to the product or its parts that meet the
factory configurations during normal use within the warranty period when there is a
performance failure within the warranty scope. The definition of performance
failures within the warranty scope, if the country has relevant regulations, shall be
based on national regulations; if there are no regulations, we will determine it in
accordance with this warranty policy.
2. Warranty period
The warranty period is one year from the date of delivery of the product. The delivery
date of online, telephone or other off-site transactions is the same as delivery date
recorded by the third-party logistics; in other cases, the invoice date should be
regarded as delivery date, but if you can effectively prove that the invoice date is
earlier than the actual delivery date and it is not caused by your end, the actual
delivery date shall prevail with our confirmation. If you are unable to provide valid
third-party logistics delivery information or invoices, the warranty date will be
calculated from 30 days after the product leaves the factory. Please see the warranty
card for the specific warranty period and other matters.
3. How to access to our services
Below optional methods for you to contact us for warranty service:
A. Service hot-line: 86 - 662 - 369 2722
B. Contact the selling platform where you buy the product.
For warranty application, please submit clear, complete and correct documents
including ① invoice；② warranty card；③ Order information on E-commerce platform
（if applicable）.
If you cannot provide above proofs indicating the source of the product, you will not
be able to obtain warranty service.
4. Warranty policy
1). Within 7 days since the start of the warranty period, if the product has a
performance failure, and it is confirmed by us or our authorized after-sales service
center, you can enjoy the return or replacement service for free. For replacement
product, the warranty period will be recalculated.
2). Within 8-15 days since the start of the warranty period, if the product has a
performance enjoy failure, and it is confirmed by us or our authorized after-sales
service center, you can free replacement or repair services. For replacement product,
the warranty period will be recalculated.
3). Within 12 months since the start of the warranty period, if the product has a
performance failure, and it is confirmed by us or our authorized after-sales service
center, you can enjoy free repair or component replacement services. The repaired
product or product with replaced components will continue to enjoy the warranty
service during the remaining of the original product. If the remaining warranty
service period is less than 3 months when warranty period the repair or component
replacement occurs, the remaining warranty period will be extended to 3 months.
4). When return or replacement is required, the product should be in original
condition in complete packaging. The main product itself as well as all the
accessories should be without any damage, scratches or breakage. For repairs, new
components become part of your product, and the components replaced should be
returned to us.
5). For product hardware failures within scope of warranty, we will bear the logistics
costs as well as other costs incurred by the warranty. For the failures or damages
that are confirmed not in the coverage of warranty, unless otherwise specified at that
time, you shall bear the round-trip freight (if any) and the risks in the transportation
process.
5. Non-warranty coverage
Warranty will not be applicable under following occasions:
1). Failures or damages caused by improper physical or operating environment,
force majeure, improper maintenance or storage, such as misuse, accident,
modification, private dismantling, liquid intake, etc.
2). Unauthorized organization or personnel dismantle or repair without our
authorization;
3). Discoloration, wear and consumption during use;
4). The relevant labels and marks of the products or parts are changed or removed,
such as: the product information or serial number on the warranty certificate does
not match the actual product, or has been altered;
5). Components with obvious damages by hard objects, scratching marks, broken
corners, severe deformations and other breakages.
6). Warranty period expires.
6. Paid services
For product failures beyond the warranty period or outside the scope of the warranty
service, we will provide paid professional repair services if it is confirmed within our
service scope. With your knowledge and agreement, the old components replaced
will be recycled when repaired. Unless expressly agreed otherwise, we will provide a
90-day warranty for the repaired or replaced components.
7. General terms
This service policy applies to the laws of mainland China (excluding its conflict
laws). If any dispute arises due to the matters under this document and the friendly
negotiation fails, it will be submitted to the People's Court with jurisdiction in
Jiangcheng District, Yangjiang City for ruling.
WARRANTY
SPECIFICATIONS
All the above parameters are tested strictly according to Q/GDBCY 015-2019 standards.
The tested battery is 18650(2600mAh 3.6V 9.36Wh) lithium-ion batteries. Performance
parameters may vary depending on test battery or environmental conditions.
1. When the light is stained with sea water or corrosive articles please clean and dry
promptly.
2. The battery of this product contains lithium-ion cell. It is strictly forbidden to take
apart the battery shell without permission to avoid possible damage to the cell or
other hazards;
3. It is strictly forbidden to disassemble, squeeze, puncture, short-circuit this product,
throw it into a fire or expose it to an environment with a temperature higher than
60°C;
4. Due to the strong light of the flashlight, please do not let children play with it and
do not irradiate on human eyes to avoid harm to the eyes
SAFETY CAUTIONS
使用无线音箱播放音乐
一 、说 明
二、保修期
三、服务获取和配合
四、保修政策
五、非保修范围
六、有偿服务
七、一般条款
保 修 卡
11. 雷鸣警报模式
12. 强制关机模式
14. 应急充电宝
13. Type-C充电
4. 手电 / 侧光灯模式切换
3. 手电主灯颜色调节
6. 音乐模式切换和连接
5. 侧光灯/警示灯/氛围灯/拾音
灯模式切换
1. 开机 / 关机
NE20161纳拓户外12合1雷鸣音乐手电
使用说明书
操作说明
保修条款
产品结构
注意事项
2. 手电亮度调节
7. 音乐模式暂停和播放
8. 音乐模式切换歌曲
9. 音乐模式音量调节
10. 音乐模式律动
产品特点
模式
手电筒
侧灯照明
性能参数
11.Buzzer Alarm Mode
Long press the button for 3.5
seconds in any mode, you could turn
on / turn off the buzzer alarm mode.
In Buzzer Alarm Mode, the flashlights
and side light all flashing alarm cycle
(Flash three times to switch one color)
with a warning alarm.
12.Directly shutdown Mode
Long press the button for
4 seconds in any mode will directly
shutdown the flashlight.
14.Emergency Charger
Rated output capacity of USBA interface
at normal temperature: 1400mAh
(5V 1A). (The discharge indicator
shows steady blue when the USBA
starts discharging, and turns off the
discharge indicator 32 seconds after
the USBA stops discharging) .
Turn on or USBA to discharge, the
discharge indicator will light up. When
the blue discharge indicator blinks, it
will be a warning of low power. Please
charge the flashlight in time.
13.Type-C Charging
Follow the turning marked to turn on
the flashlight bottom until you see the
USB Type-C charging interface. Use the
5V 1A power supply or USB adapter
with the Type-C cable to charge the
flashlight. (When charging, the indicator
light will be flashing red. It will be
flashing red when it is full.)
4.Side Lamp Brightness Adjustment
When the flashlight is in the normal
state, double -click the button quickly
to switch between the Flashlight
and Side Lamp modes.
3.Flashlight Color Modes Adjustment
When using the flashlight, press the
button to switch between different
color modes:
White→Red→Green→Blue
6.Music Mode Switch and Connection
Long press the music button for
1.5 seconds to start/close the music
mode. After startup, the side light of
the device shows Green while it is not
connected to the audio source. The
blue light will show after successful
connection, and the connection light
will turn off after music is played.
5.Side Lamp/ Warning Lamp / Sound
Atmosphere Lamp
In the Side Lamp mode, press the main
switch continuously to switch
between White light→Colorful Graduated
→Sound Atmosphere Lamp→Red Light
→Red Flash Light
1.Turn On / Off
Press down the switch for 1.5s to
turn on the light and then press down
again for 1.5s to turn off.
1. Twelve in one practical multi-functional flashlight, white/red/green/ blues focus
flashlight, Bluetooth speaker, music rhythm light, work light, camp light, sound
atmosphere light, warning light, sound and light alarm, power bank in one.
2. Full coverage of different life scenes-whether it is for car commuting, outdoor
self- driving tour, or security defense, Thunder can meet the demand for light in time.
3. The maximum brightness of the flashlight is 900 lm, and the farthest beam
distance is 245 meters. The main lamp is equipped with high bright warm white,
red, blue and green light.It adopts a Fresnel patented lens, telescopic focusing,
and quick switching between spotlight and floodlight.
4. With 360 degree adjust angle , the side lamp is functioning either as an illumination
light or a warning light. With a magnetic fixing system and tripod, it frees your
hands when being used.
5. Equipped with wireless speaker and music atmosphere lamp, you can enjoy
wonderful sound and light experience at any time.
6. With the sound atmosphere lamp, you could feel the rhythm of music.
7. High alarm plus strong light strobe, offers double guard against danger.
8. It can be used as an emergency power bank to ensure the normal operation of the
phone in emergencies.
INSTRUCTIONS
2.Flashlight Brightness Adjustment
Press the +/- button to adjust the
brightness.
7.Music Mode Pauses and Plays
You can pause or play the music by
clicking the music button
8.Music Mode Switch Song
While playing the music, you can click
the button to play the next
song, double click the button
to play the last song.
9.Music Mode Volume Adjustment
Volume Adjustment: In the music mode
Long press the +/- button to adjust the
volume of speaker.
10.Music Pulse Lamp
While playing the music, double click
the music button to turn on/ turn off
the music pulse lamp.
White Light
Red Light
Green Light
Blue Light
White Light
Colorful Light
Sound Atmosphere Lamp
Red Light
Red Flash Light
Brightness Beam
Distance
Run Time Water
Resistance
IPX4 1m
Impact
Resistance
User manual of NexTool Outdoor
12 in 1 Thunder Music Flashlight
Please read this manual before using and keep it carefully
FEATURE STRUCTURE
Magnetic Fixing System &
Tripod Mount Connection &
Direction Adjustable Holder
Telescopic
Focusing Lens
Music Pulse Lamp
Sound Atmosphere Lamp
Charging
Interface
Diffuser
Tail Switch
Discharge Interface
Sound Alarm
Wireless Speaker
Dimensions
Weight
Battery
Speaker KW
Measured
Photoelectric
Parameters
Mode
Focusing
Flashlight
Slide
Lamp
Speaker Alarm Mode
Material
Charge- discharg
Input: 5V 1A, charge time: ≈3.5h；
Output: 5V 1A, Rated Capacity: 1400mAh
173mm(L)×36mm(W)×43mm(H) ± 2mm
246g± 5g（Battery included）
18650×1（2600mAh 3.6V 9.36Wh）
4Ω2W
Metal：6061 Aluminum Alloy
Plastic：ABS, PA66+30%GF, PMMA
Charge/discharge
indicator
文件名称：纳拓户外12合1雷鸣音乐手电说明书
成品尺寸：60x120mm
展开尺寸：480x120mm
印刷材质：105克双铜纸
印刷颜色：Pantone cool gray 10C（单色印刷）
印刷工艺：风琴折页，做压痕
文件日期：2022-5-16
Please scan
then watch the
operation video
扫码观看操作视频