Document Name: WAPS Beacon NOC User Manual Document No: JGR-NN-OP-102.00-Rev1.2 Version No: 1.2 WAPS Beacon NOC User Manual Version 1.2 Company Name: NextNav, LLC.
Document Name: WAPS Beacon NOC User Manual Document No: JGR-NN-OP-102.00-Rev1.2 Version No: 1.2 History Version Date Author Notes 1.0 Nov 01, 2012 Eitan Lazarov 1 1.1 Nov 7, 2012 Subbu Meiyappan 2 1.2 Nov 15, 2012 Eitan Lazarov 3 Notes: 1. Initial Version 2. General cleanup 3. Added antenna installation warning per TCB requirments Company Name: NextNav, LLC.
Document Name: WAPS Beacon NOC User Manual Document No: JGR-NN-OP-102.00-Rev1.2 Version No: 1.2 Table of Contents History ........................................................................................................................................... 2 Notes:............................................................................................................................................. 2 1 Introduction ................................................................................
Document Name: WAPS Beacon NOC User Manual Document No: JGR-NN-OP-102.00-Rev1.2 1 Version No: 1.2 Introduction 1.1 Purpose and Scope This document includes the information of the NextNav WAPS Beacon system A4P-100-0007-01 that is required for the network deployment and Network Operations Center (NOC) operator. 2 Product specification The WAPS beacon system is intended to be used in restricted access locations (RAL) in indoor and outdoor environments under all weather conditions.
Document Name: WAPS Beacon NOC User Manual Document No: JGR-NN-OP-102.00-Rev1.2 4 Version No: 1.2 Antenna Mounting 4.1 TX Antenna Omni antenna to be installed on tower or roof top construction as defined in site specific construction drawing. As a general rule on any monopole installations the TX antenna shall be attached to a 6 foot side arm mount, minimum distance away from the monopole unless the antenna extends above the monopole in its entirety.
Document Name: WAPS Beacon NOC User Manual Document No: JGR-NN-OP-102.00-Rev1.2 Version No: 1.2 PA gain AMP BCD-8707 Andrew AVA76.5 50 30 0.66 52.01 30 AMP BCD87010 Andrew AVA510 50 30 0.66 50.66 30 30 2.46 53.61 30 Laird OD9-11 8.85 LMR-600 Note: PA Gain refers to internal system parameter. This parameter will be used by the NOC to configure the radio output power. To comply with FCC RF exposure requirements in Section 1.
Document Name: WAPS Beacon NOC User Manual Document No: JGR-NN-OP-102.00-Rev1.2 Version No: 1.2 The TX output power level setting is contained in the CSV file. The output power is adjusted by the ‘attenuation’ setting This value in the CSV file is calculated by a formula to set the output power (not to exceed 30W EIRP).