User's Manual

NOTE: The brackets come equipped with screws and inserts for mounting in stan-

dard drywall. Before you install the mounts, make sure there are no wires or other

objects, or metal plates, behind the drywall layer that will interfere with the in-

serts, screws, or mount, or mounted units.

NOTE: The Network Unit only has mounting holes on the back. The Coverage Unit

has mounting holes on the bottom and on the back. The holes on the bottom of the

Coverage Unit can be used for mounting the Coverage Unit on a ceiling. (See 6b)

REQUIRED HARDWARE

of Nextivity Inc. All other trademarks or registered trademarks listed belong to their respective owners. Designed by Nextivity Inc in

California.

Each Cel-Fi Device may be supplied with

mounting brackets and hardware to

mount both (or either) the Coverage

Unit and the Network Unit.

form-bracket-PRO-English_14-0515

Mounting Instructions

for Cel-Fi PRO

For more information, refer to the Quick Start Guide or visit www.cel-.com CEL-FI PRO SMART SIGNAL BOOSTER

Attach the Cel-Fi Unit to the wall mounted bracket.

Optional: Attach the Cel-Fi Unit to a ceiling mounted bracket.

Network Unit

Coverage Unit

For more information, visit www.Cel-Fi.com

Network

Unit

Coverage

Unit

To ensure ceiling mounting is as secure

as possible, confirm that the mounting

bracket posts are firmly inserted, and in

the correct position.

(x4)

Coverage Unit

Upside Down

(x4)

Slide Coverage

Unit until secure.

Mounting

Posts

PAGE 1
Mounting Instructions for Cel-Fi PRO 6 Attach the Cel-Fi Unit to the wall mounted bracket. Network Unit Coverage Unit Network Unit Each Cel-Fi Device may be supplied with mounting brackets and hardware to mount both (or either) the Coverage Unit and the Network Unit. Coverage Unit 6b Optional: Attach the Cel-Fi Unit to a ceiling mounted bracket. (x4) (x4) Mounting Posts Note: The brackets come equipped with screws and inserts for mounting in standard drywall.
PAGE 2
1 Determine Cel-Fi Device Location (refer to Quick Start Guide) 3G/4G/LTE Coverage Unit Back Mounting Holes Network Unit Coverage Unit 2 Determine Mounting Hole Locations Figure 1. Coverage Unit, back view with mounting holes. Coverage Unit Bottom Mounting Holes 3 Drill Anchor Holes (Drywall) In each marked spot, use a 3/16” drill bit to drill guide holes for the anchors. Figure 2. Coverage Unit, bottom view of mounting holes. Network (Window) Unit Back Mounting Holes Figure 3.