Quick Start Guide
Congratulations on your new
indoor signal solution.
This Cel-Fi system is designed to provide you with signicant
improvements in coverage as well as 3G data rates.
Setting up the system is extremely simple and
consists of placing and plugging in two components;
a Window Unit and a Coverage Unit.
By spending just a few minutes using the instructions in this
guide, you can optimize the installation and get the very most
from your new Cel-Fi System.
If you have any trouble during setup, please use the trouble
shooting steps included in this guide.
In the package you will nd:
Window Unit
Coverage Unit
Two power adapters.
CEL
-
FIRS 2
Quick Start Guide
Step 1
Find the spot with the best 3G coverage:
The rst step in setting up your Cel-Fi system is to
nd the spot in your home or oce that has the best
3G coverage. This is typically by a window, and if you
are in a multi-story building, upstairs windows are
usually better than downstairs windows.
Step 2
Plug in the Window Unit:
Take the Window Unit and one power supply out of
the box (both power supplies are the same, so grab
either one). Plug the Window Unit in, and check to
make sure that you can see at least 1 “Bar” on the
display in the center of the device. If you do not see
at least 1 bar, try a dierent location.
NEED HELP?
Visit us at
www.celfihelp.com
for an installation video and
other helpful information
regarding installation and
trouble shooting.
W I N D O W
U N I T
W I N D O W
U N I T
COVE R AGE
UN I T