User's Manual
Step 1
Find the spot with the best 3G coverage:
The rst step in setting up your Cel-Fi system
is to nd the spot in your home or oce
that has the best 3G coverage by using your
phone (3G icon must be displayed). This is typically by a window,
and if you are in a multi-story building, upstairs windows are usually
better than downstairs windows.
Step 2
Plug in the Window Unit:
Take the Window Unit and one power supply out of the box (both
power supplies are identical, so you can use either one). Plug the
Window Unit into an easily accessible outlet. Check to make sure
that you can see at least 1 “Bar” on the display in the center of the
device. If you do not see at least 1 bar, try a dierent location.
CEL
-
FIRS 2DUAL BAND
Quick Start Guide
3G
WINDOW
UNIT
WINDOW
UNIT
COVERAGE
UNIT
Congratulations on your new indoor signal solution.
This Cel-Fi system is designed to provide you with signicant improvements
in coverage as well as 3G data rates.
Setting up the system is extremely simple and consists of placing and
plugging in two components; a Window Unit and a Coverage Unit.
By spending just a few minutes using the instructions in this guide,
you can optimize the installation and get the very most from your new
Cel-Fi System. If you have any trouble during setup, please use the trouble
shooting steps included in this guide.
In the package you will nd:
• Window Unit
• Coverage Unit
• Two Power Adapters
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your
wireless provider and have your provider’s consent. Most
wireless providers consent to the use of signal boosters.
Some providers may not consent to the use of this device on
their network. If you are unsure, contact your provider.
You MUST operate this device with approved antennas and
cables as specied by the manufacturer. Antennas MUST be
installed at least 20 cm (8 inches) from any person.
You MUST cease operating this device immediately if
requested by the FCC or a licensed wireless service provider.
WARNING. E911 location information may not be provided or
may be inaccurate for calls served by using this device.
When used with any mobile device utilizing the 1710-1755
MHz band, the FCC limits booster equipment placement to a
maximum of 10 meters above ground level. Installation of this
equipment which does not comply with federal requirements
may subject the owner to FCC enforcement action.
NOT FOR RESALE.
Changes or modications not expressly approved by Nextivity,
Inc. could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help
Cel-Fi is a registered trademark of Nextivity, Inc.
Need Help?
Visit us at www.celhelp.com
for an installation video and other helpful information
regarding installation and trouble shooting.