Installation Guide
WARNING
IMPORTANT: NEVER attempt any work without shutting o the electricity.
-
Read all instructions before installing.
-
System is intended for installation by a qualied electrician in accordance with the National Electrical Code and local regulations.
-
Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or
switch ”OFF” the circuit breaker switch(es) that control the power to the xture or room that you are working on.
-
Place the wall switch in the “OFF” position.
-
Supply conductors (Power Wires) Connecting the xture must be rated minimum 90°C. If uncertain, consult an electrician.
CAUTIONS
-
These luminaires (xtures) are designed to meet the latest NEC requirements and are listed in full compliance with UL 1598.
-
Before attempting installation, check your local electrical code, as it sets the wiring standards for your locality.
INCLUDED ACCESSORIES BAG
INSTALLATION
Uses 3
” junction box, 4" junction box
or a combination
3/0-4/0
electrical box.
instructionx1
bracketx1
screwsx2
AC 120V
2
1
3
1. Fasten the ring to the Junction box with the screws,
make sure the screws are in diagonal, turn in screws
that the ring should be leveled with the ceiling.
2. Connect the wire.
3. Completing the installation by pushing in the fixture into the ring.
YOU SHOULD PREPARE
Live Your
Best Light
warranty
card x 1
www.nextglow.com