C3 User Manual Product Information Brand: Nexar Product name: Car dash cam Product model: C3 Accessory List Main Unit USB Power Cord Car Charger Suction Mount Structure & Button 1. Mount Slot 2. Heat Dissipation Hole 3. TF Card Slot 4. Speaker 5. MIC 6. RESET 7. Front Camera 8.WIFI Indicator Light 9. Working Indicator Light 10.
Power Line Wiring • Power supplied by car charger: Please refer to the red dotted line. The undercurrent could lead to malfunction.
1. Switch On/Off The device will switch on/off according to the start-up and stop of the vehicle. You can turn the device off by pressing the power button for more than 3 seconds. 2. Parking Monitor The device is stalled with 200mAh battery. When abnormal vibration is detected, the device will automatically wake up and record a monitoring video and then shutdown. You can use proper charger to prolong the monitor period.
(4) Red light flashing: Firmware updating (5) Red light on: TF card malfunction/fail to record and etc. WiFi Indicator Light (1) Blue light on: connected to the App. Attention (1) The storage temperature should be between -20℃ to 70℃ (2) Improper change of battery could lead to explosion. Please use same type of battery on the device. (3) Do not use irritating chemical solvents for cleaning. Slightly wet paper tissue or soft cloth are suggested.
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
To maintain compliance with FCC’s RF Exposure guidelines, this equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
IC Caution: EN This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.