User Manual

Chapter 4 Setting up of MyiPad System

Step 1: Install the RF receiver

Please follow these instructions carefully for RF receiver regarding connecting

distance and antenna angle to ensure proper communication between the audience

remotes and the RF receiver.

• Plug the provided USB cable into the RF receiver’s USB port.

• Plug the other end of USB cable into your computer/laptop’s USB port.

• Adjust the receiving antenna can help for boosting communication range and

signal quality.

• To optimize the signal reception, it is recommended to adjust the antenna

within an angle of 140 degrees to the audience.

• Adjust the antenna to horizontal level for best reception.

• An undesirable antenna position and angle adjustment might affect signal

communication and reduce the range of communication. The client remotes

may be unable to connect to the receiver in this situation.

Ante

nna

Horizontal

Level

PAGE 1
Chapter 4 Setting up of MyiPad System Step 1: Install the RF receiver Please follow these instructions carefully for RF receiver regarding connecting distance and antenna angle to ensure proper communication between the audience remotes and the RF receiver. • • • • • • Plug the provided USB cable into the RF receiver’s USB port. Plug the other end of USB cable into your computer/laptop’s USB port. Adjust the receiving antenna can help for boosting communication range and signal quality.
PAGE 2
Step 2: Install batteries in the remote The battery compartment is located on the back of the remote. Press down on the point shown by the arrow at the top of the compartment cover and pull up the cover to open the compartment. Precaution Remove the batteries from the remote if it is not to be used for a long period of time. If the batteries are used improperly their life will be shortened or their contents may leak. Step 3: Install the MyiPad software 1. Login Windows with an administrator account. 2.
PAGE 3
from Microsoft Windows Update or from MyiPad installation CD; otherwise skip paragraphs 4-7. 4. Install .Net framework 1.1 from Microsoft Windows Update. Copyright 2006 NewSoft Corporation Ltd. All rights reserved.