Installation Sheet

ManualsBrandsNewport Brass ManualsPlumbingVictoria Triple Handle Deck Mounted Roman Tub Filler with Handshower and Metal Lever Handles

NWP-1-587 11/29/2017

EN-3222

Rev A

Installation Instructions

ROMAN TUB 3 VALVE LONG STEM AND TRIM

Valve Body No. 1-587

Trim Kit for Model No’s: 3-1767 & 3-1777

Congratulations on the purchase of this Newport

Brass product, an excellent choice, that will give

you years of quality service and enhance the look

and style of your home.

Summary of content (5 pages)

PAGE 1
Installation Instructions ROMAN TUB 3 VALVE LONG STEM AND TRIM Valve Body No. 1-587 Trim Kit for Model No’s: 3-1767 & 3-1777 Congratulations on the purchase of this Newport Brass product, an excellent choice, that will give you years of quality service and enhance the look and style of your home.
PAGE 2
Rough In Valve Installation Recommended Installation by a Professional Plumbing Contractor Note: Use plumbers tape or equivalent to seal all threaded joints. Plumb with 3/4” copper pipe is recommended. Warning: To prevent severe damage to valve body, any solder/braze process must be performed a min. of 4" from ports. 1. Install the QUICK CONNECT FLANGE (3) through appropriate hole of mounting surface. Secure with WASHER NUT (1A). 2. Place lower WASHER NUT (1B) on VALVE BODY (12).
PAGE 3
Figure 1 See Table for Stem Height Figure 1a 1C 1C Finished 2 Deck 4 3 13 14 w𝟏 𝟒” 𝟏 w𝟏 𝟖” 𝟑 w𝟏 𝟒” 𝟏 w𝟏 𝟖” 𝟑 𝟏 7 8 11 1A 5 6 10 1B 1B w𝟏 𝟒” 9 12 12 **Remove from deck flange when installing trim Figure 2 ½” NPT *Note: Some states require an ASSE 1016 approved Tempering Valve installation with this product. See disclaimer (Figure 4 in Page 5) for proper installation.
PAGE 4
Trim Installation Note: If cartridge was removed for any reason, it MUST be re-tighten to factory torque of 14-16 ft-lbs. 1. Attach handle trim and diverter trim to valves. Any adjustments for handle rotational alignment must be made to the valve body - not to the cartridge. (Note: Allow minimum spacing between handles and escutcheon/bonnet to prevent damage to the surface finish.) Secure handles into place with screw. See Figure 3. 2.
PAGE 5
Disclaimer Regarding Brasstech Roman Tub with Hand Spray To conform to local codes and ordinances, all Brasstech Roman tub with hand spray products should be used in concert with an ASSE 1016 approved tempering valve to reduce the hot water supply to a safe temperature not exceeding 110°F (43°C).