Installation Sheet

ManualsBrandsNewport Brass ManualsTub Filler FaucetsNewport Brass Miro Triple Handle Deck Mounted Roman Tub Filler with Handshower and Metal Lever Handles

INSTALLATION INSTRUCTIONS

ROMAN TUB 3 VALVE AND TRIM

Valve Body No. 1-507, 1-578

Trim Kit for Model No’s: 1077, 1087,

1107, 1097, 1067, 1057, 1027, 967, 957,

907, 897, 887, 877, 1607, 1627, 1647,

1667, 1747, 3-2487, 3-2497

2001 CARNEGIE AVE, SANTA ANA CA 92705

(949) 417-5207

WWW.NEWPORTBRASS.COM

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS ROMAN TUB 3 VALVE AND TRIM Valve Body No. 1-507, 1-578 Trim Kit for Model No’s: 1077, 1087, 1107, 1097, 1067, 1057, 1027, 967, 957, 907, 897, 887, 877, 1607, 1627, 1647, 1667, 1747, 3-2487, 3-2497 2001 CARNEGIE AVE, SANTA ANA CA 92705 (949) 417-5207 WWW.NEWPORTBRASS.
PAGE 2
Rough in valve Installation Recommended Installation by a Professional Plumbing Contractor Note: Use plumbers tape or equivalent to seal all threaded joints. Plumb with 3/4” copper pipe is recommended. Warning: To prevent severe damage to valve body, any solder/braze process must be performed a min. of 4" from ports. 1. Install the spout quick connect shank through spacer and appropriate hole of mounting surface. Secure with washer nut. See Figure 1 2. Place lower washer nut on valve body.
PAGE 3
Table 1 Trim Installation Note: To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise rotation only. (Cartridge Bonnet factory torque is 14-16 ft-lbs.) 1. Attach handle and diverter trim to valves. Any adjustments for rotational alignment must be made to the valve body - not to the cartridge. (Note: Allow minimum spacing between handles and escutcheon/bonnet to prevent damage to the surface finish.) Secure handles into place with setscrew. 2.
PAGE 4
Disclaimer Regarding Brasstech Roman Tub with Hand Spray To conform to local codes and ordinances, all Brasstech Roman tub with hand spray products should be used in concert with an ASSE 1016 approved tempering valve to reduce the hot water supply to a safe temperature not exceeding 110°F (43°C).