Installation Sheet

INSTALLATION INSTRUCTIONS
SHOWERHEAD ASSEMBLY
MODEL NO. 2157, 2158, 2159
We recommend Installation of this product by a Professional Plumbing Contractor
Note:
Regarding fittings, the use of petroleum based plumber’s putty on our products will nullify the warran-
ty. We recommend the use of clear silicone sealing materials as outlined by the manufacturer.
To avoid damage to trim, all mating surfaces,(tile, paint, etc.), should be finished prior to trim installation.
Recommended trim for installation 517-xx, sold separately. Note: -xx designates various nipple length available for
installation requirements.
Shower Head Installation
:
As noted above, installer must use an appropriate length 1/2” NPT nipple, not included, for product installa-
tion.
1. Apply thread sealant to inlet end of NIPPLE (1a) and thread into FITTING (2) behind finished
ceiling.
2. Apply a small bead of clear silicone to backside of FLANGE (4), not included, and slide over NIPPLE (1) and
flush against ceiling.
3. Apply thread sealant to outlet end of NIPPLE (1b) and attach shower HEAD (3).
[phone]
NWP-2157 Santa Ana, Ca. 92705
06/07/2019
www.brasstech.com
Shown with Nipple / Flange assembly: #517-8 (Sold separately)
Figure 1
5
1b
1a
4
3
2