User guide

Single and Double Towel Bar / 2 & 3 Post Tissue Holder
Installation Instructions
Model No. 12-01, 12-02, 12-05, 12-09, 12-12, 12-28
Recommended Installation by a Professional Contractor
1. Using the table below, measure the appropriate distance between post centers. (See Fig. 1)
Note: Hole locations should be level.
· 18" Single Towel Bar - 18 1/8"
· 24" Single Towel Bar - 24 1/8"
· 30" Single Towel Bar - 30 1/8"
· 18" Double Towel Bar - 18 5/8"
· 24" Double Towel Bar - 24 5/8"
· Tissue Holder (2 Post) - 6 1/4"
· Tissue Holder (3 Post) - 6 1/4" (2x), (See Fig. 2)
2. Drill hole(s) in wall at points marked using the appropriate drill size:
· Wood Screw (#6 x 2”) - use: 3/32" Drill
· Toggle Screw (6-32 x 3”) - use: 3/8" Drill
3. Dis-assemble END POST (6) from POST (3). See Fig. 5. Remove ESCUTCHEON (5) from
POST (3). See Fig. 4. Loosen SETSCREW (4) in FLANGE (1) and remove POST (3).
Fasten FLANGE (1) to wall using either WOOD/TOGGLE SCREW (2). See Fig. 3.
4. Engage POST (3) into FLANGE (1). Position POST (3) height to 2 3/8“ from mounting sur -
face. Secure POST (3) into place by tightening SETSCREW (4). See Fig. 3.
5. Thread ESCUTCHEON (5) onto FLANGE POST (3). See Fig. 4.
6a. Towel Bars (Single): Assemble TOWEL BAR (7) between END POST (6). Place END
POST (6) onto POST (3) and secure into place with SETSCREW (4). See Fig. 5.
6b. Towel Bars (Double): Take the finished towel bar assemble and place onto END POST
(6), onto POST (3). Secure into place with SETSCREW (4). See Fig. 6.
6c. Tissue Holder (2 & 3 Post): Thread END POST (6) onto POST (3) and secure into
place with SETSCREW (4). Place HOLDER (7) between END POST (6). See Fig. 7.
Distance between
posts
Fig. 1
Fig. 2
Fig. 3
2
1
5
3
Fig. 4
Fig. 5
Fig. 7
6
4
6
4
7
6
6
3
Distance
between
posts
Distance
between
posts
3
3
3
3
4
2 3/8”
Fig. 6
4
6
3