Installation Sheet

ManualsBrandsNewport Brass ManualsPlumbingPressure Balanced Tub and Shower Rough In Valve with 1/2" NPT Outlet

INSTALLATION INSTRUCTIONS

Pressure Balancing Valve

Valve Body No. 1-685

as used with Tub and Shower Fittings

Description

This valve is precision engineered to provide satisfactory performance provided it is installed and operated in

accordance with our recommendations contained in these instructions. In order to fully enjoy the comfort,

safety and the reliability of this valve, be certain to familiarize yourself with these instructions.

Operation

The pressure balancing cartridge contained in this valve

compensates for pressure fluctuations in the water sup-

ply system through a spool and sleeve pressure balancing

mechanism. The outlet temperature will change by no

more than a mere ±2°F (1°C) with a 50% drop in either

the hot or cold water pressure. Even if the cold water

pressure fails completely, the anti-scald design will reduce

the flow rate to a safe level ensuring reliable protection

against scalding. The built-in check valves prevent cross

flow between the hot and cold supplies.

Illustration 1

1-685

Floor line

Tub / Shower Installation Shower / Hand shower Installation

Page 1 of 5

NWP-1-685

Note: This valve is deisnged to fit in a 2" X 4" stud wall (or thicker) installation. Use stem extension

kit #1-384 (sold seperately) if valve installed is too far away from the finished wall.

Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Pressure Balancing Valve Valve Body No. 1-685 as used with Tub and Shower Fittings Note: This valve is deisnged to fit in a 2" X 4" stud wall (or thicker) installation. Use stem extension kit #1-384 (sold seperately) if valve installed is too far away from the finished wall. Description This valve is precision engineered to provide satisfactory performance provided it is installed and operated in accordance with our recommendations contained in these instructions.
PAGE 2
BEFORE YOU BEGIN On tiled wall surfaces, grouting must be either flush or raised for proper sealing of the cover plate. IMPORTANT: It is not necessary to remove the cartridge from the valve during NORMAL soldering operations using propane-butane gas. DO NOT USE OXYGEN-ACETYLENE. When soldering connections, do not solder within 4” of valve port. Do not use excessive heat. Open the stop valves when soldering inlets.
PAGE 3
Illustration 3 Diverter stem plastic upper link finished post finished sleeve diverter knob Generic diverter trim shown-not included ASM 1-281 NWP-1-685 Page 3 of 5
PAGE 4
Setting the Temperature Limit Stop This valve has an upper temperature limit stop , which can allow desired and safe hot water temperature (recommended maximum is 110°F). This stop may be adjusted once the valve is installed. Before making this adjustment, run water with the valve turned to the hot setting. If the water temperature is too high in this position, then perform the following adjustments: 1. Remove the trim (handle, escutcheon and cover). 2.
PAGE 5
* WARNING - Never try to stop dripping by applying extreme force or overtightening the handle. MALFUNCTION CAUSE REMEDY Opening immediately to hot water. Hot and cold water supplies have been connected in reverse. Rotate cartridge 180degrees. (Illustration 7) Water drips after shutting off the valve. Residual water in valve and piping. Allow approximately 3-8 minutes to drain.* O-ring seal on the inlet of the cartridge is faulty or seat assembly is damaged.