INSTALLATION INSTRUCTIONS ROMAN TUB 3 VALVE AND TRIM Valve Model No's: 1-678 Trim Kit for Model No’s: 3-2487 3-2497 2001 CARNEGIE AVE, SANTA ANA CA 92705 (949) 417-5207 WWW.NEWPORTBRASS.
Rough in valve Installation Recommended Installation by a Professional Plumbing Contractor Note: Use plumbers tape or equivalent to seal all threaded joints. Plumb with 3/4” copper pipe is recommended. Warning: To prevent severe damage to valve body, any solder/braze process must be performed a min. of 4" from ports. 1. Install the spout quick connect shank through spacer and appropriate hole of mounting surface. Secure with washer nut. See Figure 1 2. Place lower washer nut on valve body.
Trim Installation Note: To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise rotation only. (Cartridge Bonnet factory torque is 14-16 ft-lbs.) 1. Place escutcheon over valve stem. Secure handle assembly into place by first engaging the valve stem, then position and hold the handle lever while rotating the bonnet. Any adjustments for rotational alignment must be made to the valve body, not to the cartidge. See Fig 3. 2.
Disclaimer Regarding Brasstech Roman Tub with Hand Spray To conform to local codes and ordinances, all Brasstech Roman tub with hand spray products should be used in concert with an ASSE 1016 approved tempering valve to reduce the hot water supply to a safe temperature not exceeding 110°F (43°C).