User Manual

ManualsBrandsNewport Brass ManualsFor Home1-665

Congratulations on the purchase

of this Newport Brass product,

an excellent choice, that will give you

years of quality service and enhance

the look and style of your home.

ROMAN TUB 2 VALVE AND TRIM

INSTALLATION INSTRUCTIONS

Valve Model No's: 1-665

Trim Kit for Model No's: 2046

Summary of content (4 pages)

PAGE 1
ROMAN TUB 2 VALVE AND TRIM INSTALLATION INSTRUCTIONS Valve Model No's: 1-665 Trim Kit for Model No's: 2046 Congratulations on the purchase of this Newport Brass product, an excellent choice, that will give you years of quality service and enhance the look and style of your home.
PAGE 2
Rough in valve Installation Recommended Installation by a Professional Plumbing Contractor Note: Use Teflon tape or equivalent to seal all threaded joints. Minimum deck thickness 5/8”. Recommended deck hole Ø 1.38. Warning:To prevent severe damage to valve body, any solder/braze process must be performed a min. of 4" from ports. 1. Install the quick connect spout shank through center hole of mounting surface. Secure with washer nut. See Fig. 1 2. Place washer nut on valve body.
PAGE 3
Trim Installation Note:To achieve desired handle rotational alignment, the cartridge MUST be tightened in a clockwise rotation only. (Cartridge Bonnet factory torque is 14-16 ft-lbs.) 4. Place O-RING and ESCUTCHEON over VALVE STEM. Secure handle assembly into place by first engaging the VALVE STEM, then position and holding the handle LEVER while rotating the BONNET and ESCUTCHEON. Any adjustments for rotational alignment must be made to the valve body, not to the cartridge. See Fig. 3 5.
PAGE 4
LIMITED WARRANTY Brasstech, Inc. warrants to the original consumer residential purchaser ("Original Purchaser") that if a product in its; Newport Brass ®, Brasstech ®, Motiv ®, Plumbtrim ® or GINGER® lines of products ("Product") is confirmed upon inspection to be defective in materials or workmanship during the warranty periods described below, Brasstech, Inc. will, at its option, either repair or replace the Product with a similar current model of the Product.