Wireless–N Client Adapter Quick Installation Guide Version 2.
Table of Contents English WLAN Adapter Quick installation Guide................................................................................................2 Utility and Driver Installation..................................................................................................................2 Hardware Installation ............................................................................................................................4 Wireless Network Setup..................................
Copyright statement No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, whether electronic, mechanical, photocopying, recording, or otherwise without the prior writing of the publisher. JULY 2007 WLAN Adapter Quick installation Guide Note: Ne pas insérer l'Adaptateur WLAN dans votre ordinateur avant d'avoir fini l'installation de l'Utilitaire et du Pilote. Utility and Driver Installation 1. Turn “On” your computer.
5. Click the Finish button in this screen; both the driver and the Configuration Utility are installed on your computer.
Hardware Installation For PCMCIA or USB adapters, simply insert or connect the adapter after running the setup file. For PCI cards, you must shut down the computer, plug the card in an available PCI slot, and restart the operating system. After the computer boots back up, it will detect the wireless card and then start the New Hardware Found wizard.
Wireless Network Setup 1. Peer-to-Peer: Connects with other wireless client(s). This does not require Access Point. Please make sure the “Network Name” (SSID or ESSID) and “Peer-to-Peer” channel are the same for all clients in the same wireless network. Double click on the Configuration Utility icon to open the utility. - Click on “Profile Setting” tab and “Add” to create a new profile. - Enter a name that the profile correspond, click “Next”.
WPS Function Wi-Fi Protected Setup (WPS) is a standard for easy and secure establishment of a wireless home network, created by the Wi-Fi Alliance. The goal of the WPS protocol is to simplify the process of connecting any home device to the wireless network. To secure your wireless network, you could push the “WPS” button under user interface as below: There are two ways to enable WPS connection: 1. PBC mode: Choose a Router in the list then click “PBC” button. 2.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.