MXP802GU2 Wireless-G USB Stick Adapter User Manual Ver: 1.
Contents Chapter 1 Introduction ............................................................................... 1 Product Outline....................................................................................... 1 Applications ........................................................................................... 1 Compliance Certificates.......................................................................... 2 Feature.............................................................................
Chapter 1 Introduction The MXP802GU2, a Wireless Local Area Network(WLAN) 802.11 b/g USB adapter, by inserting a PC USB socket and connecting a wireless access point through wireless interface, can provide the transmission of broadband data service. It is suitable for using in a wide range of both residential(at-home) and commercial (offices, apartments, hotels, warehouses) network applications. It gives you a blazingly fast connection to the internet, faster and more convenient.
· Voice over IP (VoIP) · Broadband internet access · Audio and video streaming and transfer · PC file and application sharing · Network and online gaming Compliance Certificates · FCC Class B · CE Mark · Wi-Fi Certification Feature · USB 1.1/2.0 interface · Comply with IEEE802.11 b/g · Support 64/128-bit WEP, 802.1x, WPA, and WPA2 for wireless security · Support 802.11e wireless multimedia Qos · Support 802.
Chapter 2 Driver Installation You should install the driver by the following steps: Step 1: Double-click the installation file (.exe), and then it pops the install shield wizard. You should read and accept the license agreement to continue the installation and then click “next”. Step 2: Then select the setup type that best suits your needs. by default, select “Newertech configuration tool” and then click “next”.
Step 3: Then choose configuration Txburst or WiFi. By default, you should select “optimize for WiFi mode” and then click “next”. Step 4: Click the “ Install ” ,then the installation begins. It takes about 20seconds to complete the installation and then click “finish”.
5
Now you could insert the USB adapter—of course, you could also insert it before executing the installation file, and then a newertechnology icon appears at the right corner of the PC， . Double-click the icon and then you could see the RaUI Utility. The nearby available wireless networks with their basic information would be listed in this interface. The USB Adapter would automatically connect to the one which has the strongest signal and without encryption.
Note1: if the desired AP is encrypted, it would pop the following message when clicking “connect”. The same encryption and password with the desired AP must be inputted to establish the connection. Note 2: if the DHCP function of the server or AP is enabled then you needn’t config the IP address of your PC. Otherwise, you need manually config the IP address of your PC in the same range with the AP. Note 3: if you want to uninstall the hardware in your PC, double-click the installation file (.
Note 4: To learn more about the application of the USB Adapter, Please Click “Help” icon 8
FCC Information This equipment complies with CFR 47, Part 15.19 of the FCC rules. Operation of the equipment is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received; including interference that may cause undesired operation.
