User Manual

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause

undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment.

INDUSTRY CANADA STATEMENTS

Operation is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including interference

that may cause undesired operation of the device.

To reduce potential radio interference to other users, the antenna type and its gain

should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more

than that permitted for successful communication.

This device has been designed to operate with the antennas listed below, and having a

maximum gain of 0 dB. Antennas not included in this list or having a gain greater than 0

dB are strictly prohibited for use with this device. The required antenna impedance is 50

ohms.

Approved antenna: On-Board PCB trace antenna

Newell Rubbermaid Inc. responsibilities to comply with FCC and Industry Canada

Regulations

The mimio Wireless Module has been certified for integration into products only by Newell

Rubbermaid Inc. integrators under the following conditions:

This module complies with FCC and Industry Canada RF radiation exposure limits

set forth for general population/uncontrolled environment. To maintain compliance,

his module must not be co-located or operating in conjunction with any other antenna or

transmitter.

PAGE 1
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 2
As long as the above condition is met, further transmitter testing will not be required. However, the Newell Rubbermaid integrator is still responsible for testing their endproduct for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).