wireless accessory for Setup Guide wireless module wireless receiver mimio software CD power supply (US ONLY) 12” receiver USB cable * For use with mimio Xi only.
System Requirements • Windows® Compatible PC with a Pentium II, 400 MHz processor minimum. • Microsoft® Windows 98SE, Me, 2000 or XP operating system. • 64 MB RAM minimum (128 MB RAM recommended). • Available USB port. Setup Process Depress the release button to remove the linkUSB module from the mimio Xi capture bar. OR Power on the device. mimio Xi can be powered by 4AA batteries or by the included AC power supply (US ONLY). Insert/slide the wireless module into mimio Xi capture bar.
User Interface Troubleshooting The wireless mimio module and receiver are programmed at the factory and are packaged as a mated pair to work “out of the box” without any user intervention. They are an exclusive pair of components that will only communicate to one another. This allows for more than one wireless mimio system to co-exist in the same environment without causing confusion over which wireless module communicates to which wireless receiver.
1. Power on the mimio Xi capture bar (with wireless module). 2. Plug the wireless receiver into an available USB port on your PC. 3. Using a paper clip, press the teach button on the wireless receiver to initiate the learning process. 4. Press the recessed learn button on the wireless module with the tip of a pen or the end of a paper clip to complete the learning process. 5. The Link Status LED will start flashing amber and green while the learning process is underway.