MODEL: PMP-3815 2.4GHZ CORDLESS TELEPHONE INSTALLATION AND OPERATING GUIDE Please read this manual carefully prior to using the telephone.
PMP-3815 TABLE OF CONTENTS Important Safety Instructions .........2 Basic Operation .............................17 Making Calls .................................17 Receiving Calls .............................17 Addit ional Options .......................17 FCC Regulations ..........................3-4 Battery Cautionary Instructions .....5 PMP-3815 Parts Checklist ...............6 Speed Dialing ................................18 Storing Phone Numbers ................18 Making Speed Dial Calls .........
FCC REGULATIONS FCC REGULATIONS Warning: Modifying or tampering with the telephone's internal components can cause a malfunction and might invalidate the telephone's warranty and void your FCC authorization to operate it. If the trouble is harming the telephone lines, the telephone company might ask you to disconnect the telephone until you have resolved the problem. 6. Programming/testing emergency numbers: When programming emergency numbers and/or making test calls to emergency numbers A.
BATTERY CAUTIONARY INSTRUCTIONS PMP-3815 PARTS CHECKLIST BATTERIES: CAUTION To reduce the risk of fire or injury to persons, read and follow these instructions: • For the cordless handset, use only 3.6V 600mAh Nickel-Metal Hydride (Ni-MH), cordless telephone battery pack (included). 2.4 GHz • Do not dispose of the batteries in a fire. The cells may explode. Check with local codes for possible special disposal instructions. In Use/ Low Batt. • Do not open or mutilate the batteries.
LOCATION OF CONTROLS AND FEATURES LOCATION OF CONTROLS AND FEATURES Talk T The T key is used to access the telephone line or end a call. Handset Redial Key R When the phone is idle or off-hook, press R to redial the last number dialed. R is also used to insert a measured pause into a number stored in the phone book. Channel Key c The c key, if pressed when the line is off-hook, will scan up to 50 channels and select the clearest one to provide the best possible reception.
LOCATION OF CONTROLS AND FEATURES LOCATION OF CONTROLS AND FEATURES Base Base Back View Antenna Data Jack TEL LINE DATA Cha Charge LED rge 9VDC 300mA Pag e Page Button Data Jack Used for connecting a computer or fax machine. Base Bottom View Tone/Pulse Switch Wall Mount Holes Page - Used to initiate a handset page. Cable Channel Charge LED - On (red) when the handset is on the cradle being charged or when the handset is in use. Flashes if the line is in use.
CHOOSING A LOCATION Do the following: • Choose the best location • Connect the phone • Choose the dialing mode TELEPHONE SETUP Connecting the Base Away from VCRs and TV sets and other electronic equipment Away from heat sources, such as radiators, air ducts, and sunlight Away from noise sources such as a window by a street with heavy traffic Away from a personal computer TEL LINE Near a central location and on a level surface Away from excessive moisture, extremely low temperatures, dust, mechanical
TELEPHONE SETUP TELEPHONE SETUP Tone/Pulse Switch Wall Mounting 1. Choose the correct dialing mode. The PMP-3815 telephone may be installed onto two screws (not included) fastened into the wall. When installing screws into plasterboard walls, use wall anchors (not included) to ensure that the screws remain secure. Insert the screws into the wall leaving 3/16" of each screw extending out from the wall. See the wall mount template on page 25 to properly space the screws in the wall for mounting.
BATTERY INSTALLATION HEADSET AND DATA JACK To install the 3.6V 600mAh cordless handset battery pack: The Data Jack 1. Slide open the battery compartment door on the back of the handset. The jack located on the side of the telephone labeled "DATA" is a convenience jack. It is useful for connecting a fax machine or modem when there is no telephone jack available for that device. 2. Plug the battery connector into the 2-pin connector in the battery compartment, and then insert the battery. 3.
SPEED DIALING BASIC OPERATION Making Calls The PMP-3815 will store up to 10 speed dial numbers. 1. Pick up the handset from the base and press T. The LED on the handset will flash while the handset is scanning for a clear channel. The handset will glow steadily when a connection is made. Wait until you hear a dial tone. Storing Phone Numbers In Use LED 2. Dial the number you wish to dial. 1. With the handset in the idle state, press l. The handset will beep. Flash Key 2.4 GHz In Use/ Low Batt.
OTHER FEATURES Using the Handset Finder (PAGE) 1. Press Page on the base. If the handset is within range, a triple beep will sound for 20 seconds. 2. Place the handset back into the base or press the c key on the handset, or press any other handset key twice, to stop the page/find feature. Security Code The security code prevents your cordless telephone conversation from being accessed by a phone on a different line.
TROUBLESHOOTING GLOSSARY No dial tone/phone will not dial out. • Check that the AC power adapter is plugged into a working AC power outlet. • Check all telephone cord connections or try another wall jack. • Do a basic reset of the phone: Disconnect the phone from the wall and remove the battery. Leave for 30 minutes and then re-install as instructed by the manual. Can’t hear the ring signal. • Check the ringer volume controls; verify that the switch is not set to “Off.
WARRANTY WARRANTY TT Systems One Year Limited Warranty within the United States • Some states do not allow limitations on how long an implied warranty lasts and/or do not allow the exclusions or limitations of incidental or consequential damages, so the above limitations or exclusions may not apply to you.
Expansion Anchor 25 Remove This Page to Mark Wall Screws needed for wall mounting: #6 or #8 Pan Head Self Tapping Screw 26 Name:______________________________ Company:___________________________ Address:____________________________ ___________________________________ City:____________State:____Zip:________ Please enclose a check or money order made out to TT SYSTEM LLC for the respective amount. Shipping and handling is included in the price.