NEWCONT NEWCONT 900 Mhz CORDLESS CALLER ID TELEPHONE WITH CALL WAITING 40 CHANNEL AUTOSCAN NTP-6210 OWNER'S MANUAL INSTALLATION AND OPERATING INSTRUCTIONS NEWCONT PLEASE READ THIS MANUAL CAREFULLY BEFORE USE. KEEP FOR YOUR REFERENCE. Made in China 2002.
Special Features C ongratulations on your selection of a quality NEWCONT product. With proper care and by following the setup and user instructions in this manual, this unit will provide you with years of trouble free service. NEWCONT is committed to providing quality products that fit your needs. We would like to have any comments or suggestions you might have on this product . You may mail your comments to: 40 Floor, Block C, Electronics science &Technology Bldg, Shennanzhonglu, Shenzhen , P.R.
Special Features FCC REGULATIONS Luminous LCD Screen - The LCD Screen emits light for 8 seconds every time you press FCC Part 15 HANDSET Volume Control Switch - Select the receiver volume level(HI.MID,LOW). any of the TELEPHONE KEYPAD buttons. HANDSET Ringer Volume Level - Select the ringer volume level (HI, LOW, OFF). Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
HANDSET Controls Notes IMPORTANT In order to get maximum life from the HANDSET battery pack, be sure to charge the HANDSET for 12 hours before initial use. 1. NEW CALL/MESSAGE WAITING LED INDICATOR IMPORTANT 2.LARGE LCD SCREEN 8. BATT LOW INDICATOR 3.HEADSET JACK LDCCF CALLS BATT MSG DIR 9.TALK BUTTON AM PM MIN NEW SEC RPT TOTAL 4. SAVE/REDIAL/PAUSE BUTTON R/P Placing your BASE UNIT near appliances such as televisions, refrigerators, radios, or microwave ovens may cause interference. TALK 10.
Technical Information HANDSET Controls Technical Information 1.HANDSET ANTENNA This cordless telephone uses radio frequencies to allow mobility. There are certain difficulties in using radio frequencies with a cordless telephone. While these are normal, the following could after operation of your system. 2.
Problem Solving BASE UNIT CONTROLS Problem Solving section For your assistance, we have listed below a few common problems. Phone does not work, check the following: 1. BASE UNIT is plugged into power source. 2. HANDSET is charged. 3. TONE/PULSE Select switch is in the right position. 4.TELEPHONE LINE CORD is plugged in the TELEPHONE JACK. Range of phone limited, check the following: 1. ANTENNA on BASE UNIT is raised. 2. BASE UNIT is centrally located in your residence. 3.
Changing the Battery Pack BASE UNIT CONTROLS Changing the BATTERY PACK 1. TELEPHONE LINE CONNECTION JACK The BATTERY PACK provides power for the HANDSET of your cordless telephone. 2. POWER-IN CONNECTION JACK 3. TONE/PULSE Select Switch To Replace the BATTERY PACK: 1. Remove the HANDSET BATTERY COMPARTMENT COVER by sliding it down. 2. Pull out the BATTERY CONNECTOR PLUG and remove the BATTERY PACK. 4. ANTENNA: Raise or reposition for the best reception. 5.