Installation Guide

4x4 Base Molding

ASSEMBLY INSTRUCTIONS

Check Box for These Contents

In the event of missing or defective parts please call our customer service department at 1 800 282 9346 (Mon. to Fri. 8:00 AM to 4:00 PM EST).

(UK Tel: (44) 2038 687160 (Mon. to Fri. 1:00 PM to 10:00 PM GMT).

Please read through before starting installation.

V1.0/072019

Top Trim Cap (4) #10086

Extrusion (4) #10145 - 5” x 5” x 7 3/8” (13 cm x 13 cm x 18.7 cm)

Bottom Trim (4) #10088

4” x 4” (10 cm x 10 cm) Post Trim (4) #10737-1

Vinyl Glue (1) #20000

4” x 4” (10 cm x 10 cm) Trim Kit

www.newenglandarbors.com

www.newenglandarbors.co.uk

PAGE 1
A S S E M B LY I N S T R U C T I O N S 4x4 Base Molding www.newenglandarbors.com www.newenglandarbors.co.uk Please read through before starting installation. Check Box for These Contents In the event of missing or defective parts please call our customer service department at 1 800 282 9346 (Mon. to Fri. 8:00 AM to 4:00 PM EST). (UK Tel: (44) 2038 687160 (Mon. to Fri. 1:00 PM to 10:00 PM GMT). 4” x 4” (10 cm x 10 cm) Trim Kit 1. 2. 3. 4. 5.
PAGE 2
STEPS 1 1 Using the glue provided, run a small bead around the inside of the base molding extrusion. 2 Carefully place the bottom trim on one end of the base molding extrusion. 3 Run another bead of glue on the other (inside) end of the base molding extrusion. 4 Carefully place the top trim cap on the base molding extrusion. 5 2 Repeat for all base moldings. Note: Please allow the glue to set for 15 minutes prior to installing the base molding on the pergola/arbor.
PAGE 3
STEPS On the Bottom Trims, there is a notch alongside the inside face. this is designed to clear screw heads during installation: 1 Typically your post would be fastened to a wooden post as shown. 1 2 3 2 The base molding then can slide down and clear the screw heads. 3 To make sure the base molding clears the screw heads, the screws fastening the post to the wooden post should be well within a 1½ in (4 cm) radius of the center of the post.