Elliott Tech, LLC OREP Installation Manual OREP New Centurion Solutions Project Number: 776 Reference: 776-91-07-REV-OREP_INSTALLATION_MANUAL.docx Original Document: March 1, 2011 Revision A: March 16, 2011 Prepared for: New Centurion Solutions, Inc. Greg Williams 3011 Spring Garden St. Suite E Greensboro, NC 27403 (336) 617-5410 GWilliams@newcenturionsolutions.com Prepared by: Elliott Tech, LLC 346 Raleigh Street Holly Springs, NC 27540 (919) 342-6899 (888) 631-1795 Fax s.elliott@elliotttech.
OREP Installation Manual 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx Revision Page Rev A Description FCC Notification Section 3 THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC. AND SHALL NOT BE REPRODUCED OR DISCLOSED IN WHOLE OR IN PART FOR ANY DESIGN OR MANUFACTURE EXCEPT WHEN SUCH USER POSSESSES DIRECT, WRITTEN AUTHORIZATION FROM NEW CENTURION SOLUTIONS, INC.
OREP Installation Manual 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx Contents 1. Equipment List ................................................................................................................................. 4 2. Installation Instructions .................................................................................................................. 6 3. FCC Notification .............................................................................................................
OREP Installation Manual 1. 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx EQUIPMENT LIST A. OREP assembly (1) B. Hardware to attach to OREP Bracket (4) C. Solar Bracket & Hardware (1) D. Bracket Hardware (2) E. Solar Panel (1) F. G. TN-Male to N-Male Pigtail 2 ft (2) H. Lightning Surge Protector (1) I. J. Tripod Base (1) K. Hardware to attach tripod to base (3) L. Mast (1) M. Antenna 3db (1) N.
OREP Installation Manual 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx O. U-Bolt and mast attachment hardware (1) P. OREP Bracket (1) Q. U-Bolts, nuts, washers (2 sets) R. TN-Male to N-Male Pigtail 2 ft (2) S. T. 12V Battery (1) Battery Box (1) U. Battery Restraining Strap (2) THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC.
OREP Installation Manual 2. 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx INSTALLATION INSTRUCTIONS To begin, check the parts available against the equipment list, identifying any missing parts. If all parts are accounted for, proceed to the instructions below to begin installing the OREP. Step 1: Identify the Mounting Base-Treated Plywood (I). Place the plywood on the ground laying flat. Identify the Tripod Base (J), open its legs until fully extended, and center it on the plywood.
OREP Installation Manual 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx Step 3: Place Antenna 3db (M) through hole in Antenna Bracket (N) and secure at base of antenna. Step 4: Identify the U-Bolt and mast attachment hardware (O). Secure the antenna-bracket assembly to the mast by sliding a u-bolt through each hole in the bracket (from previous step) and around the mast. Secure the u-bolt on the mast with two nuts (included with u-bolt).
OREP Installation Manual 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx Step 6: Note the OREP bracket has two curved half-moon shaped areas on the back of it. These areas allow the bracket to seat flushly on the mast. Identify the UBolts, nuts, washers (Q), and while holding the OREP-bracket assembly on the mast, place one u-bolt around the mast and feed through the matching holes in the OREP bracket. Secure this u-bolt with two nuts and two washers. Repeat the process for the other ubolt.
OREP Installation Manual 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx Step 8: Take Inmate 23 4#20 Female Panel Receptacle (G) and secure to OREP as shown. Step 9: Next, place the Solar Bracket (C) approx. 8-10” below the Repeater Bracket. Make sure the bracket is securely attached with two U Bolts (D). Step 10: Now attach the accompanying part of the Solar Bracket to the part already attached to the mast. Angle it at a 45 degree angle and secure tightly.
OREP Installation Manual Step 12: Take open end Receptacle (G) Attach bare wire to battery (T) negative side. Step 13: Place assembled battery (T) 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx and strip wire cover to show bare wire. White wire to positive side and black wire to inside battery box (S) Step 14: Set under middle of tripod (J) on mounting base (I) Complete OREP Assembly THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC.
OREP Installation Manual 3. 776-91-07-REV-A_OREP_INSTALLATION_MANUAL.docx FCC NOTIFICATION NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.