CATEGORICALLY OPERATED DUCT HOT RECOMMENDED FOR CHILDREN ALDER 8 YEARS OF AGE 3 WITH ALL ELECTRIC PRODUCES, PRECAUTIONS SHOULD BE OBSERVED DURING HANDLING AND USE 10 PREVENT ELECTRIC SHOCK. INPUT. 120V AG 60Hz 8W. OUTPUT. 13V DC 4m. OWNER’S MANUAL Please read and understand ail precautions prior to use. Thank you for choosing a premium New Bright product.
New Bright Section 1: Section 2: Section 3: Section 4: Section 5: Section 6: Section 7: Section 8: Section 9: Section 10: Section 11: Table of Contents Component Checklist Removing Demo Wire Charging the Battery Battery Installation in Vehicle Vehicle Features and Functions Transmitter Battery installation Transmitter Features and Functions Proper Use Precautions and Care Trouble Shooting and Support Cautions
New Bright BN 1 Component checklist FJ] To protect components from damage, they may be packed in the Styrofoam tray out of plain sight, Please search Styrofoam tray and remove all of the components shown below. Styrofoam should be saved for storing your vehicle. Vehicle 9.
New Bright Removing Demo Wir BB This vehicle is shipped with a demo wire which runs from the transmitter to the vehicle chassis. The wire is for package demonstration only and should be removed and discarded as shown here. Grasp and pull NN firmly to remove demo wire, Pull in a straight, outward direction. — Remove and discard the demo wire which runs from the vehicle to the transmitter.
LATE ef = Push up airlock Battery Release Button 1. Insert the 9.6V Lithium lon rechargeable battery pack securely into the charger and push up to lock. Be sure the arrows are properly matched {as shown above). 2.Plug the Charger into a standard indoor electrical outlet. This power unit is intended to be correctly orientated in a vertical or wall mount position. 3. Allow battery to charge for 1-1.5 Hours. Charging Status Light will be solid red while battery is charging.
Wheel Alignment” Switch (Steering Trim) Pre nice pulls to the left or right during forward driving the Steering Trim may need to disgusted.
ELE lie Press in TAB and pull back to open battery compartment cover. Install 2 “AA” batteries as shown, making sure and markings on batteries line up with the and markings in the battery compartment. Note: When replacing Transmitter batteries: Use alkaline batterings only. Do not mix oid and new batteries. Do not mix alkaline, standard or rechargeable batteries. Close battery compartment cover. Cover should click when locked in place.
cE ul Gly wy Features and Functions BR START MUTE: HORN: Press to hear Press to hear sound. Press horn sound. again for mute. Press to select 2 wheels drive or 4 wheels drive St Sounds will continue as long as car is active. Press again fo tum off the sounds. Press start fo reactivate sounds. Forward/Reverse Left/Right Driving Steering Note: Vehicle has working headlights and brake tights. When driving forward or reverse the headlights will turn on.
Proper Use Switch vehicle OFF Brush areas where when not in use. dirt gets trapped. Wipe body with a Do not use chemicals soft rag or cloth. _ or water to clean.
90% of all difficulties experienced with radio controlled vehicles are due to either weak batteries or batteries that have been installed incorrectly. When batteries become weak, the vehicle may not necessarily stop completely but may exhibit slow response, slow speed or erratic behavior. Problem Vehicle does not move or moves slowly. Make certain there are fresh alkaline batteries in the transmitter and that they have been installed in the correct position.
New Bright caution Do not recharge Battery Pack if it is hot or warm to the touch. Allow Battery Pack to cool before recharging. Recharging a hot or warm Battery Pack will shorten the life of the Pack. Do not recharge a Battery Pack if it appears to be damaged or leaking. Always unplug Battery Charger when not in use. Always remove Battery Pack from Battery Compartment when not in use. Do not dispose batteries in fire. Leakage, explosion and personal injury may occur. Dispose of Rechargeable Battery.