Aw Wei FULL FUNCTION FCC ID: Gépazsy RADIO CONTROL NO. 435 Battery Requirements: ANTENNAS are packed | Transmitter: 248 Alkaline Battery in shipping foam in bo.
TROUBLE SHOOTING AND CARE FOR R/C VEHICLES Are the + and ~'s contacts correctly matched in transmitter? Are the metal contact fobs touching, rusty or dirty in transmitter? Are there batteries in vehicle ond transmitter? Is the power switch on vehicle turned on? Is the battery/power pack weak or out of power? There is radio interference in the area. Another R/C vehicle with the same frequency is close by. The buttery is weak or fading. Batteries are not Alkaline, are miss notched or are old.
Push antenna wire 2. Insert tube into through hollow tube. hole on vehicle. knot may be died at the top. © [Do not pull wire tight) Screw antenna in tightly for best transmission, Be sure the + and — cre properly mooched, BATTERY INSTALLATION IN VEHICLE 1 2. 3 Remove the battery cover which is located behind the driver cabin. Insert 2x AA size alkaline batteries in the battery compartment. with positive and negative ends matching the markings. Replace battery cover.
Radio waves control and drive the vehicle. Any of the following conditions may interfere with the behavior and function. The transmitter signals can easily be interrupted, coring for your transmissible and vehicle is illustrated on these pages. Do not abuse your vehicle! Remember fo avoid water, heat, sand and high impact crashes! Off road vehicles may run on greasy areas. CEE Ell SRR Laconic winsomeness ore very smi ta dines sunlight ox Tina.
Range Vehicle may go beyond radio signal conic, Lass of control or slaw mess will be dent when out of range, Hold transmitter antenna up high for bes reception, Interference Erratic behavior, Jose of contact or aching motion may occur in areas of high tension wires, shone pales or CB radios. Brush areas where dirt and dust get rapped. Gy Wipe body off with q soft rag or tact cloth.
Vehicle Operation Button Press Power Bucket Button @ once to activate Power Bucket operation. The working safety light on the vehicle will start blinking when Power Bucket Bunion @ is pressed. POWER ARM: * Move joystick @ upward to lift the power arm. * Move joystick (® downward to lower the power arm. POWER BUCKET: * Move joystick @ upward to dump. * Move joystick @ downward to SCOOP. Crass Vehicle Operation Button (TD) once fo stop blinking light. The vehicle is resumed fo vehicle operation mode.
Turn ON/OFF switch on vehicle to the ON position for power, After play, always turn vehicle off. Remove, 244 battery , when not in use or when stored. leakage may occur and cause damage if left for a period of time. & ATT uss, i Operation Button Press Vehicle Operation Button (1) once to activate Vehicle Operation mode. FORWARD STEERING: * Move joystick @ upward to steer right in forward drive. * Move joystick @ upward fo steer left in forward drive.