User's Manual

Product Overview
Packing list
Power on/o
Charging
Scanner
Speaker
Denoise MIC
Fingerprint
RFID
Power Key
Flashlight Key
Right Scan Key
USB Port
Lanyard Slot Charging Contacts
Host x1 USB cable x1
User Manual x1 Lanyard x1
Flashlight
Top Camera
Front Camera
Earphone
LED Indicator
Function Key
Left Scan Key
Locating Slot
Microphone
Light/Proximity
Sensor
Touch Panel
& Display
Spotlight
Power on: Press and hold the power key for three seconds
until the screen displays the startup screen.
Power o: Press and hold the power key for three
seconds to bring up a dialog box and select "Shutdown".
If abnormal, please press and hold the power button for
ten seconds and reboot.
To prevent possible hearing damage,
do not listen at high volume levels for long
Warning
※Use of an unapproved or incompatible power supply or
charger may cause fire, explosion or other hazards.
※Use only accessories approved by the device manufac-
turer that are compatible with this model. Use of other
types of accessories may violate the warranty of this
device and may result in a safety incident.
※Charging must be performed in a well-ventilated and
well-discharged environment, away from flammable and
explosive materials.
※Any kind of battery short circuit may cause serious
consequences such as explosion, fire or personal injury!
The indicator light changes from red to orange when
charging and turns green when fully charged.
It is normal that the battery will have slight heat during
charging. After the battery is fully charged, disconnect the
charger from the AC power and then disconnect the product.
87
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE
DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS
Safety Statement
-10~60 ° C. Avoid using the product in environments
where the temperature is too high or too low.
※Turn o the machine at chemical plants, gas stations,
and other places that are prone to explosion.
※Use caution when using this product near pacemakers,
hearing aids, and other medical electronics. It may interfere
with these devices.
※To avoid demagnetization, keep this product away from
magnetic materials such as floppy disks, credit cards, etc.
※Avoid exposing the product to strong sunlight or high
humidity.
※This product has a camera and recording function,
please follow the relevant laws and regulations.
※Do not store this product near water heaters, micro-
wave ovens or high-pressure vessels.
※Do not disassemble, modify, or repair this product.
In order to use your wireless digital terminal safely and
eectively, please read the following information before
use:
※The product's ambient temperature for use is:
Disclaimer
ed by copyright, patents, trademarks and other intellectual
property rights.
In any case (including negligence), any direct or indirect,
incidental, special or consequential loss or damages, attor-
neys' fees, various expenses or any other losses arising
therefrom, from any content or service provided by the
product or the company does not warrant the accuracy,
validity, timeliness, legality or completeness of damages,
or the results of any information contained in or connect-
ed with any content or services used by you or any third
party.
Users shouvld understand that all content and services
available through this product are third parties and protected
FCC Compliance
Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursu-
ant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and,
ifnot installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communi-
cations.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the equip-
ment o and on, the user is encouraged to try to correct
the interference by one or more of the following mea-
sures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and
receiver.
—Connect the equipment into an outlet on a circuit dier-
ent from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV techni-
cian for help.
Health and safety information
Radio Frequency (RF) Energy
This model phone meets the government’ s
requirements for exposure to radio waves.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired operation.
For any unauthorized third-party applications download-
ed or installed on the product by the user himself or
uploaded or downloaded by any third-party applications,
including incompatible software and products installed,
Neusoft Corporation does not bear any responsibility for
legality, quality or any other aspects, and the user bears
the relevant risks. Any liability or damage caused by using
this product in a manner not consistent with the intended
use of the product and the use described in the user
manual is at the user's own risk.
This phone is designed and manufactured not to exceed
the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission of
the U.S. Government:
The exposure standard for wireless mobile phones
employs a unit of measurement known as the Specific
Absorption Rate, or SAR. The SAR limit set by the FCC
is1.6W/kg. Tests for SAR are conducted using standard
operating positions accepted by the FCC with the phone
transmitting at its highest certified power level in all
tested frequency bands. Although the SAR is determined
at the highest certified power level, the actual SAR level
of the phone while operating can be well below the maxi-
mum value. This is because the phone is designed to
operate at multiple power levels so as to use only the
poser required to reach the network. In general, the closer
you are to a wireless base station antenna, the lower the
power output.
The highest SAR value for the model phone as reported
to the FCC when tested for use at the ear is 0.463W/kg
and when worn on the body, as described in this user
guide, is 1.277W/kg (Body-worn measurements dier
among phone models, depending upon available enhance-
ments and FCC requirements).
While there may be dierences between the SAR levels
of various phones and at various positions, they all meet
the government requirement.
The FCC has granted an Equipment Authorization for
this model phone with all reported SAR levels evaluated
as in compliance with the FCC RF exposure guidelines.
SAR information on this model phone is on file with the
FCC and can be found under the Display Grant section of
http://www.fcc.gov/oet/fccid after searching on
FCC ID:2ASMA-S611
For body worn operation, this phone has been tested
and meets the FCC RF exposure guidelines for use with an
accessory that contains no metal and the positions the
handset a minimum of 1 cm from the body. Use of other
enhancements may not ensure compliance with FCC RF
exposure
Guidelines. If you do not use a body worn accessory and
are not holding the phone at the ear, position the handset
a minimum of 1cm from your body when the phone is
switched on.
Neusoft Corporation
Service Address: No.901 Huangpu Road, Dalian, Liaoning,
P.R.China
Zip Code: 116085
Customer Service Tel: [phone]
Fax: [phone]
E-mail: [e-mail]
Website: www.neusoft.com
Disposal
The equipment must be returned to a collection point for
electronic equipment waste disposal. Defective batteries
must be returned to a collection point for chemical waste
disposal.
The company will not bear any responsibility for the
consequences of non-compliance with the above sugges-
tions or improper use.
If the content described in this manual does not match
your product, please take the product as the standard.
We reserve the right to modify the contents of this
manual at any time without prior notice. We extend our
apology for the inconvenience!
Restrictions
This device is restricted to use and put into service due
to the need for a spectrum license and/or the conditions
attached to authorization for the use of frequencies
within all European Unioncountries(BE/BG/CZ/D-
K/DE/EE/IE/EL/ES/FR/HR/ITCY/LV/LT/LU/HU/MT/NL/AT/PL
PT/RO/SI/SK/FI/S E/UK).
Wireless Digital Terminal S611 Series
User Manual
2019-03-15
技术要求：
材质：157克铜版纸，四色双面印刷 专色PANTONE 300U
尺寸：350x108mm,折叠后尺寸：70x108mm
折叠图示：
/
9
1
内四