Murata 1DX Integration Guide Neurio Technology ULC 2022-12-02
Murata 1DX Integration Guide FCC ID of this product is as follows. • FCC ID: W72-1DX For Neurio Technology ULC integration use in host product(s) only. Device cannot be sold to general public. Contents 1. Voltage 2. Antenna 3.
1. Supply Voltage Min. Typ. Max. Unit Specification Temperature Range -10 +25 +55 Deg C Specification Voltage VBAT 3.2 3.6 4.2 V VDDIO 1.71 1.8 or 3.3 3.
2. Antenna Please perform antenna design that follows the specifications of the antenna The concrete contents of a check are the following three points. １）It is the same type as the antenna type of antenna specifications. • Confirm the same size as the Gerber file. ２）An antenna gain is lower than a gain given in antenna specifications. • Measure the gain, and confirm the peak gain is less than the application value (1.4dBi) ３）The emission level is not getting worse.
3. Notice For Neurio Technology ULC integration use in host product(s) only. Device cannot be sold to general public. The following statements are required by FCC/IC to be included on the product and in the Installation manual. Contains Transmitter Module FCC ID: W72-1DX Or Contains FCC ID: W72-1DX • Please describe the following warnings in the manual. This device complies with part 15 of the FCC Rules.
3. Notice • When installing it in a mobile equipment. Please describe the following warning to the manual. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body. • When installing it in a portable equipment. - It is necessary to take a SAR test with your set mounting this module.
3. Notice This device is intended only for Neurio Technology integration use under the following conditions: 1)The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2)The transmitter module may not be co-located with any other transmitter or antenna. 3)The use of an antenna with gain less than 1.4 dBi. As long as 3 conditions above are met, further transmitter test will not be required.
3. Notice End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID:XXXXXXXXXX”. The grantee's FCC ID can be used only when all FCC compliance requirements are met.
