ZigBeeTM- Wall Switch User Manual Battery-Powered Wall Switch (ON/OFF / Dimmer/Door Bell/ Panic Button/ Scene & Mode Selector) Model: ZB02C 20140103 FW V1.0 HW V5.
1. Introduction Netvox ZB02C, a battery-powered wall switch, acts as an End Device in ZigBee network. It does not perform permit-join function as a coordinator or a router for other devices to join the network. It can be bound with the On/Off devices such as ZigBee enabled power plugs or power outlets. What is ZigBee? ZigBee is a short range wireless transmission technology based on IEEE802.15.4 standard and supports multiple network topologies such as point-to-point, point-to-multipoint, and mesh networks.
2. Product Appearance Opening Indicator Button 1 Button 2 Button 3 Button 1 Button 2 Button 3 Binding Key Battery Holder 3. Specification y Fully IEEE 802.15.4 compliant y Utilizes 2.4GHz ISM band; up to 16 channels y Power supply: 2 x AAA batteries.
. Installation Diagram Insert the batteries Install the cover 5. Setting up ZB02C 5-1. Turn On ZB02C For power saving, ZB02C is designed to get into sleeping mode when there is no activity for 2 minutes. To manually turn on ZB02C, press the Binding Key once. y When ZB02C is first time used or after resetting → it will try to join the network. y When ZB02C is in a ZigBee network → it will send out the device data, like IEEE address/Network address, and the indicator will flash 5 times.
-2. Join the ZigBee Network After ZB02C is turned on, it will search for an existing ZigBee network and send a request to join the network automatically. While ZB02C is under the coverage from a coordinator or a router whose permit-join feature is enabled, ZB02C will be permitted to join the network. Step1. Enable the permit-join function (valid for 60 seconds) of a coordinator or a router (please refer to the user manual of the coordinator or the router to enable the permit-join feature). Step2.
5-5. Battery When the operating voltage is lower than 2.4V, the indicator will flash once. ZB02C will send a low-power report to the ZigBee network. 5-6. Restore to Factory Setting To restore it to factory setting, please follow the steps: Step1. Remove the batteries to power off ZB02C. Step2. Press and hold the Binding Key, then power on ZB02C. Step3. The indicator will generate flashes, and the restore is completed. 6. Important Maintenance Instructions • Please keep the device in a dry place.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.