ZigBeeTM- Humidity/Temperature Sensor User Manual Battery-Powered Humidity/Temperature Sensor/Ultraviolet Sensor Model: Z716A 20130802 FW V1.1 HW V1.
1. Introduction Netvox Z716A, a humidity/temperature sensor with LCD display, acts as an End Device in ZigBee network. It does not perform permit-join function as a coordinator or a router for other devices to join the network. The humidity/temperature data can be also sent to the ZigBee network center wirelessly. What is ZigBee? ZigBee is a short range wireless transmission technology based on IEEE802.15.
2.
3. Specification y Fully IEEE 802.15.4 compliant y Utilizes 2.4GHz ISM band; up to 16 channels y Power supply: 2 x 1.5V AA batteries y Operating consumption: ≤ 40mA y Standby consumption: ≤ 0.
4.
5. Setting up Z716A 5-1. Turn On Z716A To manually turn on Z716A, press the Binding Key once. y When Z716A is first time used or after resetting → it will try to join the network. y When Z716A is in a ZigBee network → it will send out the device data, like IEEE address/Network y address, and the LCD display will show for 2 minutes. When Z716A was in a ZigBee network, but by any change it is offline → it will start to rejoin the ZigBee network. 5-2.
. y Z716A can be bound with up to 10 devices. 5-4. Sleeping Mode Z716A is designed to go into sleeping mode for power-saving in some situations: A. While the device is in the network → the sleeping period is 5 minutes; it will wake up every 5 minutes to keep online. B. When it doesn’t find a network to join → Z716A will go to sleeping mode. It will wake up every 15 minutes to search a network to join. C.
5-8. Restore to Factory Setting To restore it to factory setting, please follow the steps: Step1. Press and hold both Binding Key and Setting Key for 5 seconds. Step2. Release the button after the LCD display flashes. Step3. After the display shows , the restore is completed. 6. Important Maintenance Instructions • Please keep the device in a dry place. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrode electronic circuits.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
