User Manual NETVOX TECHNOLOGY CO., LTD. Add: No. 21-1 Sec. 1 Chung Hua West Road, Tainan, Taiwan Tel: +886-6-2617641, 2654878 Fax: +886-6-2656120 http://www.netvox.com.tw Copyright© Netvox Technology Co., Ltd.
CC2430 Programming instruction CC2430 has a adjusting interface which allows program Flash inside . Adjust interface pin: P2_1 (Debug Data) P2_2 (Debug Clock) Reset CC2430DB board or CC2430EB board can be used to program with RF Module or USB Dongle device. Just to connect the interface shown in below figure with the corresponding pin of RF module or USB dongle is O.K. . Programming file : HEX file DD(P21) ANTENNA DC(P22) Reset CC2430 3.
The programming interface for RF Module and USB Dongle is shown in figure below : Programming software is: SmartRF04Prog.exe(TI).
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user manual of the end product. The user manual which is provided by OEM integrators for end users must include the following information in a prominent location.