User’s Manual NETVUE II Model Number: NI-1300, NI-1301, NI-1302 NetView Technologies keeps the right of the document updated with the new service offer or the service change Version:1.
Basic installation 1. Plug in the included Ethernet cable to the Ethernet port on the backside of the camera and connect it to the Ethernet port (Not WAN port) of the router, so as to access internet. (Note: DHCP service of the router must be available. You can check the DHCP service by a computer. The computer can automatically obtain IP address if the DHCP service is available. If not, please refer to User’s Manual of the router on how to set up DHCP.) 2.
. Add camera After login, now click Add New Camera on the page of my camera in the user control center. In the popup window enter the camera’s ID in the bar Camera ID (This ID No. is a unique identity of the camera which is marked on the label of camera’s back panel or package of the camera), then give the camera your favorite name in the bar Camera Name (allow digits, letters and underline). Click Submit button to finish this step. Finally, the added camera is displayed in the list of My cameras.
9. Delete camera You can delete your camera from your user account. On the page of My cameras list, move the mouse to the top right corner of the camera icon, then click the button X when it appears. You can re-add the camera by the same steps as above if you want it again. 10. Two-way audio Click the talk icon , the camera side can hear your voice after you speak close to the microphone at your computer.
8. Two-way audio: Click the talk icon , the camera side can hear your voice after you speak close to the microphone at your iOS devices. Other users who receive your camera by Share function, will only hear the voice from the camera side, and can’t hear your voice at iOS devices. in the top right corner on the 9. Motion detection and alert: Click the settings icon page of playing video, and you can enable or disable the motion detection and push notification.
. WiFi configuration: Please click the settings icon in the top right corner on the page of playing video, and click Configure WiFi. When the WiFi list is enabled, select your WiFi and enter its password. Then click Confirm to configure. There will be prompt that appears to instruct you, to unplug Ethernet cable after 15seconds, and then wait for 3-5 minutes for the camera to get online and workable to play. If it fails, please plug in Ethernet cable and reconfigure WiFi again. 7.
14. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
