User’s Guide IEEE 802.
FCC Certifications Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, 3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change.
DGT 警語 : 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得 擅自變更頻率、加大功率或變更原設計之特性及功能。 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現 象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依 電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科 學及醫療用電波輻射性電機設備之干擾。 本模組於取得認證後將依規定於模組本體標示審合格籤，並要求平台上標示 「本產品內含射頻模組：ID 編號」 3
Unpacking information Before getting started, please verify that your package includes the following items: 1. 2. 3. 4. IEEE 802.11n Wireless mini PCI Three detachable antennae One Quick Installation Guide One Utility/ Manual CD Installation Guide Note: The following driver installation guide uses Windows XP as the presumed operation system. For Linux and Mac driver installation guide, please refer to the instruction in /Driver/Linux and /Driver/Mac in the CD-Rom.
3. Select if you are going to configure your wireless network with this device or with Microsoft Zero Configuration tool. (Note: This can be changed after installing this software.) 4. Select to optimize this adapter in WiFi mode or performance mode. Note: The performance mode is only available while connecting to a TX Burst supported AP. Users that uses the AP without TX Burst please select WiFi mode (standard mode). 5. Click the Install button to start installing. 6. Click the Finish installation.
To connect with Configuration tool Microsoft Zero 1. Right click on the icon on system tray. 2. Select View Available Wireless Networks to specify your wireless network. 3. The tool shows the available wireless networks. Select your demanding network to connect with. To connect to a wireless network with more security settings, please click Change advanced settings to be compatible with your wireless network security settings.
To connect with 802.11n Wireless LAN utility As default, the Utility is started automatically upon starting your computer and connects to a connectable wireless network with best signal strength. Right click on the icon and select Launch Config utilities if the Utility does not start. You can change the connecting network by clicking on the network name and click the Connect button.
