DriverI/DCM-NA1-200 Manual Rev: 1.0 11 th Feb 2022 DriverI/DCM LTE Connectivity Module (FCC ID: 2AM8R-DCM-NA1-200) Company Name: Netradyne Inc. Contact: San Diego Office: 9191 Towne Centre Drive Suite 200 San Diego, CA 92122 Call Us: 1-833-476-9663 Email: driveri@netradyne.com Web Page: https://www.netradyne.
Rev. A0-10 Table of Contents 1. INTRODUCTION ............................................................................................................................................ 3 DRIVERI/DCM MODULE DIMENSIONS ................................................................................................................... 4 1.1 1.2 LTE MODULE (WP7611 – SIERRA WIRELESS): .........................................................................................................4 GPS MODULE: ......
Rev. A0-10 1. Introduction This document is designed to provide information about DriverI/DCM for customer use. DriverI/DCM Module is an LTE Dongle designed for US region will be used to provide high precision navigation and LTE Connectivity using T-Mobile Carrier. DriverI/DCM Device contains FCC ID – 2AM8R-DCM-NA1-200 For external host interface "DriverI/DCM Module" supports USB interface with 12V DC supply input. DriverI/DCM Module dimensions are 66.5mm x 66.5mmx21.2mm .
Rev. A0-10 DriverI/DCM Module Dimensions Figure 1: DriverI/DCM Module Dimensions 1.1 LTE Module (WP7611 – Sierra Wireless): WP7611 is an LTE embedded wireless module. This LTE Cat-3 embedded module delivers up to 100 Mbps download speed and is ideal for IoT applications requiring broadband connectivity such as industrial gateways, transportation, and mission-critical networking applications.
Rev. A0-10 Driver/DCM device includes GPS module that deliver high integrity, precision timing in demanding applications world-wide. Support for BeiDou, GLONASS and Galileo constellations enables compliance with national requirements. Enhanced sensitivity and concurrent constellation reception extend coverage and integrity to challenging signal environments.
Rev. A0-10 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
Rev. A0-10 maintenue entre le corps de l'utilisateur et le combiné, y compris l'antenne. Les pinces de ceinture, les étuis et autres accessoires similaires utilisés par cet appareil ne doivent pas contenir de composants métalliques. Les accessoires portatifs qui ne répondent pas à ces exigences peuvent ne pas se conformer aux exigences d'exposition RF et doit être évitée.