Manual

NM-IRJBOX
NetMedia, Inc., 10940 N. Stallard Place, Tucson, Arizona 85737 [phone] Fax: [phone] Email: [e-mail] www.netmedia.com
MAN-IRJBOX REV0707A
Infrared Illuminator
NM-IRJBOX
No visible light or red glow
Lets cameras see in complete darkness
Works with NetMedia Day/Night color cameras
No visible red glow
Wide angle of IR dispersion
Built-in Y-Cable for sharing power
Mounts in standard electrical xtures
Includes Mounting Bracket
Includes power supply
1 year limited warranty
Product Includes:
1. IR Illuminator Board (IR LED’s, Power Y-Cable).
2. 12V DC 300mA Power Transformer, Center Conductor Positive.
3. Black Lens Cover Insert.
4. Mounting hardware (Bracket and Screws).
The NetMedia IRJBOX Infrared (IR) Illuminator provides invisible light for IR (940nm) sensitive cameras. It
enables cameras such as NetMedia’s VIDJBOX-HB (SC53) to see in complete darkness. The illuminator mounts in
a wall with its bracket or in a typical single gang junction (light switch) box. It is concealed behind a black cover
plate insert that allows only IR to pass. For best results, do not mount in the same junction box as the camera.
IR Illuminator Board
940nm IR LED’s provide invisible light
for camera without red glow. Power
Y-Cable provides female input and
male output for 12V DC power.
Lens Cover
Black insert conceals
Illuminator, snaps into
Cover Plate.
Mounting Bracket
Installs in Wall Cutout.
Illuminator also mounts in
a junction box.
Wall Cutout
Not Included
Cover Plate
Not Included
Installation Procedures:
1. Connect the 12V DC 300mA Power Transformer from an AC outlet to the Illuminator’s Power Input Connector. If sharing
power through the Y-Cable, make sure there is enough current for both devices; the Illuminator requires 200mA.
2. Install Illuminator Board into Mounting Bracket or Junction Box (not included). Check camera to ensure that the desired
area is illuminated without shining, either directly or by reflection, into the camera lens.
3. Snap the Black Lens Cover into the Cover Plate (not included) by pressing all four corners in simultaneously. If necessary,
the square corners of the insert may be slightly rounded.
4. Attach the Cover Plate to Mounting Bracket or Junction Box. Silicon or similar sealant may be used as needed.
FEATURES SPECIFICATIONS
Infrared Illuminators:
Illumination Range:
Power Requirement:
Power Connectors:
Mounting Holes:
Size:
Weight:
64- 940nm LED’s
Up to 6 ft.
12V DC 200mA
1 Male, 1 Female 5.5mm OD, 2.1mm ID, center positive
3.8” centers
4.25” long x 1” wide x 0.2” thick
0.8 oz.
(subject to change without notice)