Installation Instructions

Table Of Contents
Wireless Keyboard And Mouse Combo
5163+4W282
NETKRAFT INC
BATTERY INSTALLATION
The mouse requires two AAA batteries.
They keyboard requires an AA battery
Installing the batteries on th mouse
Step 1: Open the battery compartment located below
the mouse
Step 2: Insert the batteries
Step 3: Close the compartment
Installing the battery on the keyboard
Step 1: Open the battery compartment
located below the keyboard
Step 2: Insert the battery
Step 3: Close the compartment
CONNECTING RECEIVER
The receiver must be plug into a
direct USB port or a USB extender.
Connect the USB receiver to your computers USB port.
MULTIMIDIA FUNCTION
Play and Pause
Stop
Previous
Next
Volume-
Volume+
Mute
Home Page
WIRELESS RECEIVER
1.The reciver is in a compartment located at the back of keyboard
2.The compartment is used to store the receiver during transport.
PROBLEM-SOLVING
When you mouse has problems,check:
1.If the batteries have been in use for a long time,replace with
new batteries.
2.If the mouse LED is on but still unrunning,follow the steps below.
Step1.Disconnect and connect the receiver to the USB port
available from the computer.
Step 2.Place the mouse near the receiver (about 10 cm),remove
the batteries and reinstall the batteries to the mouse.
If the mouse turn on,the mouse is ready for use.
ENERGY SAVING
To save battery power,our product has an energy-saving system,
avoiding unnecessary mouse and keyboard expense when both
are not in use.
Stand-by mode: If the devices are not used for 45 seconds,they
will go into Stand-by mode.
Suspension mode: If the devices are not used for 15 minutes,they
will go into Suspension mode,and you need to press any button
to wake them up.

Summary of content (2 pages)