Wireless Network Adapter User manual Wireless Network Adapter User’s Manual Page 1 of 8
Federal Communications Commission (FCC) Requirements, Part 15 This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Wireless Network Adapter User manual Table of Contents Chapter 1 Introduction ...................................................................... 3 1.1 Welcome .............................................................................................................................. 3 1.2 About This Guide .............................................................................................................. 3 1.3 Copyright statement.............................................................
Wireless Network Adapter User manual Chapter 1 Introduction 1.1 Welcome The Wireless Network Adapter is a powerful 32-bit USB Adapter that installs quickly and easily into PCs. The Adapter can be used in Ad-Hoc mode to connect directly with other cards for peer-to-peer file sharing or in Infrastructure mode to connect with a wireless access point or router for access to the Internet in your office or home network. The Wireless USB Adapter connects you with 802.
Wireless Network Adapter User manual 1.5 Before you begin You must have at least the following: A laptop computer/desktop PC with an available USB slot At least a 300MHz processor and 32MB of memory Windows 2000, XP USB controller properly installed and working in the laptop computer A 802.11g or 802.11b Access Point (for infrastructure Mode) or another 802.11g or 802.11b wireless adapter (for Ad-Hoc; Peer-to-Peer networking mode.
Wireless Network Adapter User manual needed. Hold the adapter and insert it into a USB slot. Figure 3-1 If the Found New Hardware Wizard displays, choose Install the software automatically (Recommended), and click Next button. The driver will be installed automatically. Figure 3-2 You have now completed the driver and hardware installation for the Adapter.
Wireless Network Adapter User manual 3.2 Configuration your wireless adapter Now right-click on this icon, and then select the “View Available Wireless Networks” Figure 4-1 The Wireless LAN Configuration screen will appear automatically. So, choose one of the “Available wireless networks” one this list, and configure the “network key” for your computer. At last, click “Connect” button.
Wireless Network Adapter User manual Chapter 4 Troubleshooting This chapter provides solutions to problems that may occur during the installation and operation of the Wireless USB Adapter. Read the descriptions below to solve your problems. 1. The Wireless USB Adapter does not work properly. Reinsert the Wireless USB Adapter into your PC’s USB slot. Right click on My Computer and select Properties. Select the device manager and click on the Network Adapter.
Wireless Network Adapter User manual with multiple clients associated to it. Check that the Network Connection for the wireless client is configured properly. If Security is enabled, make sure that the correct encryption keys are entered on both the Adapter and the access point. APPENDIX A Specifications Standards: IEEE 802.11g, IEEE 802.11b Modulation: 802.11b: CCK (11 Mbps), DQPSK (2 Mbps), DBPSK (1 Mbps); 802.
