R netis Wireless N VDSL2 VoIP IAD Quick Installation Guide
netis Wireless N VDSL2 Modem Router Quick Installation Guide 1.Package Contents netis Wireless N ADSL2+ Modem Router Quick Installation Guide MODEM PHONE V Wireless N VDSL2 VoIP IAD Power Adapter VDSL Splitter Ethernet Cable Telephone Cable *2 QIG 2.Hardware Connection 3G dongle (or USB storage device) 2.1. Connect the DSL line with the attached telephone cable. Connect the LINE port of VDSL Splitter to the wall jack with a telephone cable.
netis Wireless N VDSL2 Modem Router Quick Installation Guide 3. Configure the Modem Router via Web Management Page 3.1. Necessary Information before the configuration. For a successful setup, you're recommended to contact your ISP first and ask for the following network parameters which will be required during the configuration procedures. a. VPI/VCI; b. Connection Type; c. Encapsulation Type (Optional); d. Username & Password (Optional, according to your Connection Type). 3.2.
netis Wireless N VDSL2 Modem Router Quick Installation Guide 3.4. After you login the web management page, you can go to "Wizard" to do basic configurations step by step 1) Step 1: ISP Connection Type. Select the ISP Connection Type that given by your ISP. After selection, please click NEXT to continue. 2) Step 2, PPPoE/PPPoA. When PPPoE/PPPoA is selected, Enter the PPPoE/PPPoA information provided to you by your ISP.
netis Wireless N VDSL2 Modem Router Quick Installation Guide 3)Step 3, Wireless Settings, You may enable/disable Wireless, change the Wireless SSID and Authentication type in this page. Click NEXT to continue. 4)Step 4, the Setup Wizard has completed. Click on BACK to modify changes or mistakes. Click NEXT to save the current settings. Tip 1: Default IP address: 192.168.1.
netis Wireless N VDSL2 Modem Router Quick Installation Guide 4.Troubleshooting Q How do I restore my netis Modem Router's configuration to its default settings? A With the router powered on, use a pin to press and hold the Default button on the rear panel for 8 to 10 seconds before releasing it. The router will reboot and all configurations are back to factory default. Q What can I do if my Internet cannot be accessed? A 1) Check to verify the hardware connections are correct.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PKUM05755 NETIS SYSTEMS CO., LTD. www.netis-systems.
