R netis Wireless N VDSL2 Modem Router Quick Installation Guide
CONTENTS English 1 Español 6 Português 11 Français 16
netis Wireless N VDSL2 Modem Router Quick Installation Guide 1.Package Contents netis Wireless N ADSL2+ Modem Router Quick Installation Guide MODEM PHONE V Wireless N VDSL2 Modem Router Power Adapter VDSL Splitter Ethernet Cable Telephone Cable *2 QIG 2.Hardware Connection 1 2 3 4 2.1. Connect the DSL line with the attached telephone cable. Connect the LINE port of VDSL Splitter to the wall jack with a telephone cable.
netis Wireless N VDSL2 Modem Router Quick Installation Guide 3. Configure the Modem Router via Web Management Page 3.1. Necessary Information before the configuration. For a successful setup, you're recommended to contact your ISP first and ask for the following network parameters which will be required during the configuration procedures. a. VPI/VCI; b. Connection Type; c. Encapsulation Type (Optional); d. Username & Password (Optional, according to your Connection Type). 3.2.
netis Wireless N VDSL2 Modem Router Quick Installation Guide 3.4. After you login the web management page, you can go to "Wizard" to do basic configurations step by step 1) Step 1: WAN Connection Setting, please select Channel Type in advance. Select ATM for ADSL configuration or PTM for VDSL configuration and then you can have each setup page for configuration. 2) If ATM is selected, please set PVC (VPI/VCI) value, Encapsulation, Connection Mode, IP Protocol from your ISP.
netis Wireless N VDSL2 Modem Router Quick Installation Guide 3) Select the Connection Mode that given by your ISP. After finish the configuration, click "Next" to continue. If "Bridge" is selected, select the Connection Mode defined by your ISP. If "IPoE" is selected, choose IP Protocol, WAN IP Settings, and DNS Settings that given by your ISP. If "PPPoE" or "PPPoA" is selected, choose IP Protocol, input the Username/Password and DNS Settings that given by your ISP.
netis Wireless N VDSL2 Modem Router Quick Installation Guide 4) In step 2 Wireless Fast Settings, you can configure your Wireless settings and then click "Next" to continue. 5) If you want to finish the settings in this Wizard, please click "Apply Changes", otherwise, please click "Cancel" or "Prev". Tip 1: Default IP address: 192.168.1.
netis Wireless N VDSL2 Modem Router Quick Installation Guide 4.Troubleshooting Q How do I restore my netis Modem Router's configuration to its default settings? A With the router powered on, use a pin to press and hold the Default button on the rear panel for 8 to 10 seconds before releasing it. The router will reboot and all configurations are back to factory default. Q What can I do if my Internet cannot be accessed? A 1) Check to verify the hardware connections are correct.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PKUM05662 NETIS SYSTEMS CO., LTD. www.netis-systems.
