Wireless Lan 802.11n miniPCI User’s Manual Version 1.
Web Site: www.gemtek.com.tw E-Mail: sales@mail.gemtek.com.tw Phone: +886-3-598-5535 Fax: +886-3-598-5585 WNR834M IEEE 802.11b/g with EWC Mini-PCI Wireless LAN Module Specification Product Name WNR834M Host Interface miniPCI Dimensions 59 x 89 x 3.5 mm (non standard size, for module only) Frequency Band 2.400 ~ 2.
Web Site: www.gemtek.com.tw E-Mail: sales@mail.gemtek.com.tw Phone: +886-3-598-5535 Fax: +886-3-598-5585 Security TBD- (Hardware 64/128-bit WEP; WEP weak key avoidance; TKIP; hardware AES engine, WPA, 802.1x and 802.11i) Driver ? Standards IEEE 802.11b, 802.
1 2 3 4 5 MARVELL SEMICONDUCTOR PROPRIETARY INFORMATION D D EEPROM SDRAM U4 CardBUS miniPCI PCI C Y1 U13 U3 Interface WMIM-205GN Block Diagram WLAN 802.11g/b Wireless 40 MHz XTAL U7 2.4 GHz PA U5 U6 Switch 88W8361P U8 Switch Switch A Antenna Connect A U9 U11 B Filter C 88W8060 2.4 GHz PA Table of Contents: BP1 1.2V U2 Power Supplie 1. Title Page 2. MiniPCI connector 3. JTAG, SPI EEPROM, and Power Supply 4. 88W8361P SoC Interface 5. Memory DRAM/Flash 6.
IC statement Operation is subject to the following two conditions: 1) This device may not cause interference and 2) This device must accept any interference, including interference that may cause undesired operation of the device. IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. As long as 2 conditions above are met, further transmitter test will not be required.