Learning Thermostat Installation Guide
Compatibility Go to nest.com/works to make sure Nest will work in your home and find out if you’ll need Nest Concierge professional installation. Watch the video Before you install Nest, watch the installation video at nest.com/support Questions? Visit support or give us a call at 855-4MY-NEST.
Contents Display Base Nest Screwdriver Wall Screws Optional Trim Plate Steel Plate Screws for Steel Plate
1. Switch off power 2. Remove cover This protects you and avoids blowing a fuse. Adjust the temperature on your old thermostat to make sure your system is off. Some covers pop off, while others need to be unscrewed. Breaker Box Switch 3. Check your system 4. Remove any jumper wires If your old thermostat is labeled 110V or 220V or has thick wires with wire nuts, your system is high voltage. Not sure? Contact support. Jumper wires are short wires between two connectors. Nest doesn’t need them.
. Label wires Peel off the blue labels and attach them to your wires. Tip: Take a picture of the wires on your old thermostat to help you remember. 6. Disconnect wires and remove base Tip: Wrap the wires around a pencil to keep them from falling into the wall. 7. Mark where screws will go Use the bubble level to make sure Nest is level.
Optional in most homes Use trim plate if needed You can cover up holes or marks left by your old thermostat with the optional trim plate. Place the trim plate on the wall and put the base on top so they snap together, then screw them both to the wall. The trim plate can be found in the bottom of the Nest box. Optional in most homes Mounting Nest on an electrical box Electrical boxes aren’t common, but if you have one, secure the steel plate to the electrical box with two of the short steel plate screws.
8. Attach base 9. Connect wires After all wires are connected, make sure they’re flush with the wall. 10. Attach display 11. Switch power back on Press the display until it clicks into place.
12. Setup and Nest Account Nest will turn on and start setup. Turn the ring and press to select. Connect Nest to Wi-Fi during setup, then visit nest.com/home to create a Nest Account so you can control Nest from anywhere. For more information visit nest.com or call 855-4MY-NEST (855-469-6378) Recycle your old thermostat: see nest.
Federal Communications Commission (FCC) Compliance Notice: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Industry Canada (IC) Compliance Notice: This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.