User's Manual

ManualsBrandsNeptune Technology Group ManualsElectronicsWireless LAN Radio

ACS Report: 02-0177-15C Page 1

FCC Part 15 Subpart C

Frequency Hopping

Spread Spectrum Transmitter

Certification Test Report

Appendix H

Installation Guide

Manufacturer:

Neptune Technology Group

Model:

R900-v2

Variants:

◊ Pit Mounted MIU with External

Antenna

◊ Wall Mounted MIU with

Integrated Antenna

FCC ID:

P2SNTGSRFV2

ACS Report Number:

02-0177-15C

Summary of content (7 pages)

PAGE 1
FCC Part 15 Subpart C Frequency Hopping Spread Spectrum Transmitter Certification Test Report Appendix H Installation Guide Manufacturer: Neptune Technology Group Model: R900-v2 Variants: ◊ Pit Mounted MIU with External Antenna ◊ Wall Mounted MIU with Integrated Antenna FCC ID: P2SNTGSRFV2 ACS Report Number: 02-0177-15C ACS Report: 02-0177-15C Page 1
PAGE 2
Model: R900-v2 Advanced Compliance Solutions FCC ID: P2SNTGSRFV2 3. Information to User FCC Notice This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 3
Model: R900-v2 Advanced Compliance Solutions FCC ID: P2SNTGSRFV2 Connect the 3-conductor wire to the encoder register’s terminals per the manufacturer’s instructions, using the color code in Table 1. 1. 2. 3. 4. Thread the cable around the strain relief posts of the encoder. Apply moisture protection compound to the terminal screws and exposed wires. (Neptune recommends Dow Corning Compound #4). Snap the cover onto the encoder register. Proceed to the section entitled “Installing the MIU.
PAGE 4
Model: R900-v2 1. 2. 3. 4. 5. 6. 7. Advanced Compliance Solutions FCC ID: P2SNTGSRFV2 Feed the antenna cable and housing through the 1 ¾” hole in the meter pit lid. Slip the large plastic nut over the antenna cable and thread it onto the antenna assembly to secure it to the pit lid (Figure 1). Connect the coaxial cable connector to the connector on the transmitter housing (Figure 2).
PAGE 5
Model: R900-v2 ACS Report: 02-0177-15C Advanced Compliance Solutions FCC ID: P2SNTGSRFV2 Page 5
PAGE 6
Model: R900-v2 ACS Report: 02-0177-15C Advanced Compliance Solutions FCC ID: P2SNTGSRFV2 Page 6
PAGE 7
Model: R900-v2 ACS Report: 02-0177-15C Advanced Compliance Solutions FCC ID: P2SNTGSRFV2 Page 7