User's Manual
Table Of Contents
- Motion 5In1 User Manual
- Z-Wave™ Network Inclusion/Exclusion/Reset
- Association
- Z-Wave™ Message Report
- Command Class Configuration
- 1)Led Indicator Enable
- 2)Motion Enable
- 3)Motion Alarm Once Enable
- 4)Luminance Associated Enable
- 5)Binary Sensor Report Enable
- 6)Motion Sensitivity
- 7)Temperature Offset Value
- 8)Humidity Offset Value
- 9)Temperature D-Value Setting
- 10)Humidity D-Value Setting
- 11)Luminance D-Value Setting
- 12)Basic Set Level
- 13)Motion Blind Time
- 14)Basic Set Off Delay Time
- 15)Motion Clear Time
- 16)Luminance Threshold for Associated
- 17)Sensor Measuring Interval
- 18)Light Intensity Offset Calibration
- Wakeup Command Class
- Battery Command Class
- Command Class Basic
- SmartStart
- Led Action Indicator
- All Supports Command Class
1
Motion 5In1 User Manual
(NAS-PD07Z1U)
Version
Written By
Date
Change List
1.0
Yongqi
20200330
Initial
1.1
Yongqi
20200529
Change Some Errors.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help