User Guide

ManualsBrandsNEO ManualsElectronicsZ-Wave Plus Siren Alarm with Strobe alerts, Support USB Charge and with Back up Battery Works with SmartThings, 105dB

Table Of Contents

HOW TO ADD A DEVICE HANDLER FOR THE NEO COOLCAM SI

HOW TO ADD A DEVICE HANDLER FOR THE

NEO COOLCAM SIREN IN SMARTTHINGS?

1. Log in here with the same username and password

you use for your SmartThings

app: https://consigliere-regional.api.smartthings.co

2. Click on “My Device Handlers” in the top menu. （fig.1）

3. In the top right corner, click on ”Create new device handler” (fig.2) and choose ”From

code” (fig.3) from the top tab menu. You'll be presented with a blank area where you can

copy the code from this link and paste it in.:

https://community.smartthings.com/t/release-neo-coolcam-siren/156537

Summary of content (4 pages)

PAGE 1
HOW TO ADD A DEVICE HANDLER FOR THE NEO COOLCAM SIREN IN SMARTTHINGS? 1. Log in here with the same username and password you use for your SmartThings app: https://consigliere-regional.api.smartthings.co m 2. Click on “My Device Handlers” in the top menu. （fig.1） 3. In the top right corner, click on ”Create new device handler” (fig.2) and choose ”From code” (fig.3) from the top tab menu. You'll be presented with a blank area where you can copy the code from this link and paste it in.: https://community.
PAGE 2
4. Next, scroll to the bottom and click Create (fig.4). Now click Save, then click Publish > for me. (fig.5) [NOTE] You should only add the Siren Alarm to SmartThings after the device handler is created. If you already added the device, remove it and add it again into your system, and the siren alarm will automatically detect the device handler.
PAGE 3
5. Where can you find “Type” and select the correct option? 1) IDE website > My Devices > Display Name (to find the NEO siren and click) > 2) Edit (under the page) > Type > select "Neo coolcam siren" . . .
PAGE 4
[NOTE] Simply exclude the device if you had included it prior to installing the new device handler. Then add the device to your SmartThings hub by clicking on Add thing > + Connect New Device in your app. Press and release the Z-Wave button on the sensor third quickly. Remember to keep the device within 3 feet away from your hub during inclusion — the device should be automatically discovered as the NEO Coolcam Siren Alarm. Then, leave the sensor by the hub for a few hours so it can fully configure.