Operation Instructions

Wireless Remote Control Operation Instructions

Remote control introduction

1. Indicator light: when the button is pressed, the indicator light flashes to indicate that a signal

has been sent, when the remote control indicator light is always on and the battery is weak, it

indicates that the battery is low, just replace the battery.

2. Direction buttons: you can remotely move to the right or move to the right.

3. Start/stop button: press once to start, if you want to pause, press again to pause.

4. Speed button: speed adjustment button.

Remote control parameters:

Remote control battery model: CR2032 lithium battery

Remote control standby time: 6 months

Continuous working time of remote control: 18H

Normal use of the remote control: 60,000 times

Wireless remote control distance: 6 meters

FCC Warning:

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

PAGE 1
Wireless Remote Control Operation Instructions Remote control introduction 1. Indicator light: when the button is pressed, the indicator light flashes to indicate that a signal has been sent, when the remote control indicator light is always on and the battery is weak, it indicates that the battery is low, just replace the battery. 2. Direction buttons: you can remotely move to the right or move to the right. 3. Start/stop button: press once to start, if you want to pause, press again to pause. 4.
PAGE 2
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules.